ABB Series Panduan Pengguna - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pengontrol ABB Series. ABB Series 12 halaman. Area controller

POWER REQUIREMENTS

This product requires a transformer capable of providing 24VAC power to the product. Use of a UL listed 24VAC

transformer is recommended.

To connect power, use the supplied two-position terminal plug. The output leads from the transformer should

be connected to the terminal plug. The terminal plug is then connected into the socket marked J1 on the PCB.

American Auto-Matrix recommends using 18AWG cable for power wiring.

Figure 1-5 Connecting Power to MATRIX Series Area Controller

WARNING: Do not share the power source for Aspect MATRIX Series MAX Area Controller with other

devices. Damage to the product as a result of improper power and wiring will void product

warranty.

The PCB of the product includes diagnostic LEDs, providing user feedback when power has been connected to

the device. When power is connected, all three of the LEDs should be illuminated. The power diagnostic LEDs

are located near port 1's terminal block switches.

Figure 1-6 Power LEDs on Aspect MATRIX Series Area Controller PCB

Subject to change without notice

WWW.CYLON.COM

Hardware Layout

MATRIX Series |