Ayra ERO 540 MKII Panduan Pengguna - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Perlengkapan Lampu Ayra ERO 540 MKII. Ayra ERO 540 MKII 11 halaman. Rgb led movinghead
Halaman CetakIf you have any problems with DMX lighting, consult this troubleshooting section to solve any difficulties with
your product. If this troubleshooting section does not solve your problem, contact your dealer for more
information and help.
This troubleshooting section contains the most frequent problems and is not a complete collection of possible
faults, defects and solutions. The troubleshooting section applies for DMX controllers, DMX cabling and DMX
lighting fixtures. It is possible that not all described problems, causes and solutions apply to your situation as
product details may vary from product to product.
Problem
The fixture does not activate itself
The fixture does not respond to
DMX signals
The fixture does not respond to
sound
The beam output is very low
Sometimes the DMX signal is lost
and/or some fixtures are
flickering / behaving odd
sometimes
DMX lighting troubleshooting
Possible Cause
Blown fuse
No power cable plugged in
Power switch is not in the ON
position
Wrong DMX address
DMX controller blackout function
activated
Faulty positioning of the DMX
polarity switch on the controller
No response or DMX activity
signal LEDs active
Wrong working mode selected.
Microphone sensitivity level is set
too low
Speaker placed too far away or
lack of bass
Dirty/dusty optics
Dimmer is not set to full output
Faulty/broken DMX cables
Power cable interference on your
DMX signal
No DMX terminator
Solution
Check the fuse compartiment for
blown fuses and replace it if
necessary.
Plug in the power supply to a
matching power outlet
Turn on the device by switching
the ON/OFF switch to the ON
position, if available
Set the DMX address to the right
value
Deactivate the blackout function of
your DMX controller
flip the polarity switch on your
DMX controller
Check your DMX cables for
possible connection breaks and
replace them if necessary.
Check if the sound activated mode
of the fixture is activated.
Increase the microphone
sensitivity of the built-in
microphone
Place your lighting effect closer to
your speakers (or vice versa)
and/or increase low frequency
volumes. The microphone will not
be triggered with high pitched
sounds.
Clean the lens and/or other optics
with a dry or damp cloth
Set all dimmer levels to 100% on
your DMX console
Check your DMX cables for
possible connection breaks and
replace them if necessary.
Avoid installing the DMX and
(high) power cables parallel to
each other.
Apply a DMX terminator at the end
of your DMX-chain