Ayra 9000-0048-9727 Panduan Pengguna - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemindai Ayra 9000-0048-9727. Ayra 9000-0048-9727 17 halaman. Led scanner
Halaman Cetak
To activate the device, plug it into a mains socket. Once it's connected to an active power source, it will turn
on automatically.
During calibration, 'AYRA' will be shown on the display, which means the device is not ready to be operated.
Once the device has fully started up, it will jump to the last-used mode. Operation modes and other settings
shown on the display can now be adjusted or changed by means of the menu buttons.
Should the device detect a DMX signal, it will automatically switch to DMX mode and will display the last-
used address. For new devices, this will normally be DMX address 001. Of course, you can change the DMX
address via the display using the menu buttons.
Using the display and the menu buttons, you can adjust the functions and settings of the device. Press
'Enter' to confirm an adjustment or select a function, use 'Up' and 'Down' to change amounts and 'Menu' to
go back to the menu. By holding the 'Menu' button down for 2 seconds after saving a specific setting, the
device will return to operation mode and adopt the setting. This will also be done after any changes in the
operation mode or DMX address. This operation is not always necessary, considering the device
automatically does this after a new setting is confirmed.
The menu contains the following options and functions
display
Mode
ADDR
DMX address configuration
CHND
Channel mode selection
RCND
Remote Control mode
SLND
Slave mode
SHND
Show mode (for sound-activated
operation)
AUTO
Automatic mode (speed user-
adjustable)
SPLC
Split Colour on/off
SOUN
Sound-controlled mode (activates
built-in microphone)
SENS
Sound sensitivity
BLND
Blackout mode in case of signal
loss
LED
LED Display on/off when not in
use
DISP
Display inversion
PAN
Invert Pan (mirror)
TILT
Invert tilt (mirror)
TEST
Test mode
HOUR
Time registration
VER
Firmware version number
RSET
Reset function
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials:18-02-2017 RV
Operation and mounting
Function
Address A001 ... A512
1CH/8CH/10CH
Specific addresses available for compatible
controllers (RC 1-4 adjustable)
Master - NAST
Slave 1 – SL 1
SH0 random show
SH1-16 show program 1-16
AU0 random show
AU1-16 show programma 1-16
(Adjust the speed per program by holding down
the 'Enter' button and using the Up/Down keys to
select a speed between 1 and 9. 1=slow, 9=fast)
YES (Split colour on)
NO (Split colour off)
Mode: ON / OFF
000 – 100: Sensitivity in %
Yes: Blackout mode will activate in case of DMX
signal loss
No: Switch to standalone mode in case of DMX
signal loss
ON/OFF
Display inversion, disp - dslp
NO – do not invert pan
YES – invert pan
NO – do not invert tilt
YES – invert tilt
This mode tests all the functions displayed to
make sure they are working properly.
0000 – 9999 usage in hours
Display of firmware version number (can not be
updated by user)
Starts up and recalibrates the device again
Revision date and author's initials: -