Ayra WSM Black 03 Panduan Pengguna - Halaman 10
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin Kabut Ayra WSM Black 03. Ayra WSM Black 03 18 halaman. Dmx fog machine
Halaman Cetak
Operation and mounting
In order to use this fog machine as intended by the manufacturer, Ayra recommends following the steps
below and reading the instructions thoroughly before use.
Fluid
Before turning on the device, the fluid tank should be filled with a sufficient amount of smoke fluid. Keep the
tank half full for best results. This device functions best with fluids made by Ayra. Good smoke fluid does not
leave residue behind, is more efficient, creates longer-lasting smoke, and produces an almost odourless
mist. The use of other types of fluids could have a negative impact on the lifespan of this machine, and could
result in hazardous hot spatters of fluid.
The WSM Black 01 has a tank capacity of approximately 1.8 litres. The WSM Black 02 and 03 both have
tank capacities of approximately 2.3 litres.
Always fill the tank about 3/4 full instead of completely full. This prevents the contents of the tank from
spilling over if the machine is adjusted or moved.
How much fluid is used depends on many factors, including the type of machine, the type of fluid used and
the characteristics of the room where the machine is being used. It is therefore impossible to give an exact
amount.
As a rule, 1 litre of smoke fluid is sufficient to produce a layer of mist that lasts all evening in a small well-
ventilated venue.
Monitor the fluid level is closely while the machine is in use. The fluid level is clearly visible but the machine
does not automatically warn you if the fluid level is too low.
If the fluid level is too low, then the pump will make more noise and the smoke production will decrease
considerably. If this happens, stop producing smoke immediately and fill the tank with fluid according to the
standard procedure. If the machine runs without fluid for a longer period of time, permanent damage may
occur.
Positioning and installation
The WSM Black smoke machine is designed to be used standing upright or suspended in a stable
construction. In order to prevent unauthorized use of this machine, it is recommended to place it somewhere
out of reach of others, but where you can still monitor it at all times.
If the machine is positioned on a bar, DJ booth or table, the surface needs to be sturdy and able to withstand
heat . Do not place the machine on a surface that is covered with a sheet, tarp, table cloth or foil.
Keep children away from hanging cables and make sure that cables on the floor that are attached to the
machine do not form a tripping hazard.
If the machine is suspended in a truss, at least three of the following instructions need to be followed:
- mount the bracket of the machine using the included hardware.
- tighten the knobs firmly, but not too tightly so that the device can no longer be moved or tilted.
- make sure the load capacity of mounting hardware such as G-hooks or half couplers is sufficient to carry
the weight of the machine.
- attach a safety cable (optionally available) to the machine's safety eyelet when suspending it in a truss.
- attach the (optionally available) safety cable in such a way that the device can't fall more than 30 cm before
the safety cable prevents it from falling any further. Wrap the safety cable multiple times around the truss
construction to keep the falling distance to a minimum.
Before mounting the device to the wall, beam or ceiling, it is recommended to contact a specialist who can
provide advice and proper hardware. A second point needs to be made for attaching the safety cable and the
procedure described above needs to be adhered to.
Warming up
Once the machine has been turned on, the internal heating element needs time to reach the right
The information in this user manual is subject to change at any time without notice.
Version: 1.0
Date of creation and author's initials: 29-07-2017 RV
Revision date and author's initials: -