AccuStrata FLUOROTEK 200 Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Alat Ukur AccuStrata FLUOROTEK 200. AccuStrata FLUOROTEK 200 17 halaman. Handheld fluorometer
Juga untuk AccuStrata FLUOROTEK 200: Panduan Memulai Cepat (2 halaman)

Halaman Cetak
2. Install 4 - AA batteries as indicated at the bottom of the battery housing.
3. Replace the battery protection panel by inserting the panel into the groves and sliding up
into position.

1.4. General Information, Precautions and Cleaning

The sample compartment is designed to accommodate standard polypropylene 0.5 ml
Polymerase Chain Reaction tubes as shown below:
Any other sample holder besides those displayed above are not guaranteed to fit
properly in the sample holder. Do not use solvents inthe test tube that may penetrate or
degrade the integrity of the tube. See tube manufacture instructions for further
information.
If a sample is accidentally spilled inside the sample compartment, invert the Fluorotek
200 unit to drain the fluid from the compartment. Then carefully wipe the inside of the
compartment with a clean cotton swab or cloth. Allow the unit to dry before using.
The Fluorotek 200 is NOT waterproof and should be kept away from water and moisture.
Do not expose the Fluorotek 200 unit to temperatures below 5 ⁰C or above 40 ⁰C.
2. Instrument Operation
2.1.
Instrument Power Up
To turn on the Fluorotek 200, toggle the power switch on the top right side of the unit to the left.
To turn the unit off, toggle the power switch right.
If the Fluorotek 200 is left on for more than 30 minutes, the unit will power off automatically.
Once the system is turned on, a
Once the
H
S
OME
CREEN
AccuStrata Fluorotek 200 User's Manual
L
S
OADING
CREEN
appears, the system is ready for use.
will appear followed by the
H
S
:
OME
CREEN
3 |
P a g e