Cisco 7926G Panduan Administrasi - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Administrasi untuk Telepon IP Cisco 7926G. Cisco 7926G 14 halaman. Wavelink avalanche management console
Juga untuk Cisco 7926G: Catatan Rilis (16 halaman), Panduan Aksesori (20 halaman), Panduan Administrasi (19 halaman), Panduan Pengguna (10 halaman), Panduan Pengguna (16 halaman), Panduan Administrasi (23 halaman), Panduan Instalasi (12 halaman), Panduan Instalasi (21 halaman)

Halaman Cetak
Cisco 7926G Panduan Administrasi
Wavelink Settings Fields
Item
Network Services Level
Security Level
User Interface Level
Wireless Level
Audio Level
System Level
Wavelink Settings Fields
You can configure Wavelink settings from the phone CU. The following table describes the Wavelink settings.
Table 4: Wavelink settings
Setting
Enable
Use Alternate Server
Alternate Server
Custom Name 1-4
Custom Value 1-4

Update Phone

When you have completed the phone configuration changes, you must export the configuration file from the
phone CU to Wavelink, and then update the phone.
Note
The CU does not perform a complete validation of the phone configuration. If the configuration file
contains an invalid setting, the phone may reject the configuration and send an error message to the syslog.
To update the phone with the updated configuration file, perform the following steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
12
Description
DHCP, TFTP, CDP data.
Application level security data.
Key strokes, softkeys, MMI data.
Channel scanning, authentication data.
RTP, SRTP, RTCP, DSP data.
Firmware, upgrade data.
Description
Enables the Wavelink server.
Enables the use of alternate Wavelink server.
If the User Alternate Server is enabled, enter an IP address for the alternate
server.
Assign up to four attribute names to the phone to be used as selection
criteria.
Define the values for each Custom Name to be used as selection criteria.
Wavelink Avalanche Server