Siemens SN25E230EA Petunjuk Penggunaan Manual - Halaman 8
Jelajahi secara online atau unduh pdf Petunjuk Penggunaan Manual untuk Mesin pencuci piring Siemens SN25E230EA. Siemens SN25E230EA 28 halaman.
Halaman Cetak
en
Rinse aid
As soon as the rinse-aid refill indicator
lights up on the control panel,
8
refill with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses.
Use only rinse aid for domestic dish-
washers.
Combined detergents with rinse-aid com-
ponent may be used up to a water hard-
ness of 21 _dH (37 _fH, 26 _Clarke,
3,7 mmol/l) only. If the water hardness
is over 21 _dH, rinse-aid must be used.
Open the dispenser
and lifting the plate on the cover.
Carefully pour rinse aid up to the max.
mark in the filler opening.
Close cover until it clicks shut.
To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
8
by pressing
29
Setting amount of rinse-aid
The amount of rinse-aid dispensed can
be set from
to
Do not change the amount of rinse-aid
unless streaks (select lower setting) or
water stains (select higher setting) are left
on the utensils.
Close the door.
Switch on ON/OFF switch
Press and hold down the Start button
.
4
Rotate programme selector
is indicated on the digital display
5
.
Release button.
The factory-set value
digital display
Change the setting as follows:
Rotate programme selector
the required value is indicated on the
digital display
5
Press Start button
The rinse-aid refill indicator
out.
The set value is saved.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
Proceed as described under "Setting
amount of rinse-aid" and set the value
to
.
The rinse-aid refill indicator
switched off.
.
.
1
until
3
is lit on the
5
.
until
3
.
.
4
goes
8
is
8
is now
8