Siemens ED HSB Series Informasi Untuk Penggunaan - Halaman 16
Jelajahi secara online atau unduh pdf Informasi Untuk Penggunaan untuk Kompor Siemens ED HSB Series. Siemens ED HSB Series 24 halaman.
Halaman Cetak
en Hob-based hood control
20.7 Remote diagnostics
Customer Service can use Remote Diagnostics to ac-
cess your appliance if you contact them, have your ap-
pliance connected to the Home Connect server and if
Remote Diagnostics is available in the country in which
you are using the appliance.
Tip: For further information and details about the avail-
ability of Remote Diagnostics in your country, please
visit the service/support section of your local website:
www.home-connect.com.
20.8 Data protection
Please see the information on data protection.
The first time your appliance is registered on a home
network connected to the Internet, your appliance will
transmit the following types of data to the
Home Connect server (initial registration):
¡ Unique appliance identification (consisting of appli-
ance codes as well as the MAC address of the Wi-Fi
communication module installed).
21 Hob-based hood control
If the hob and the extractor hood are Home Connect-
compatible, connect the appliances in the Home Con-
nect app. To do this, connect the two appliances to
Home Connect and follow the instructions in the app.
Notes
¡ Using the controls on the extractor hood always
takes priority. It is not possible to use the hob-based
hood control during this time.
¡ You can only connect to the extractor hood via the
Home Connect app. Other connection routes are no
longer supported.
21.1 Controlling the extractor hood via the
hob
In the basic settings for your hob, you can adjust the
behaviour of your extractor hood depending on
whether the hob or individual cooking zones are
switched on or off.
You can select other settings using the controls on the
hob.
Note: If you cannot find these settings for your hob,
check the settings of the extractor hood in the
Home Connect app to configure the connection.
Connecting the fan
In order to set the hood from the hob, you must first
▶
assign the hood function to Favourite button.
→ "Favourite button", Page 10
If you assign the hood function , you can choose
between setting the fan, automatic mode or the
hood lighting.
Setting the fan
Requirement: The function is assigned to Favourite
button.
16
¡ Security certificate of the Wi-Fi communication mod-
ule (to ensure a secure data connection).
¡ The current software and hardware version of your
appliance.
¡ Status of any previous reset to factory settings.
This initial registration prepares the Home Connect
functions for use and is only required when you want to
use the Home Connect functions for the first time.
Note: Please note that the Home Connect functions
can only be utilised with the Home Connect app. In-
formation on data protection can be retrieved in the
Home Connect app.
Press
.
1.
Select the required setting in the settings area.
2.
You can select the following settings:
Note: Available depending on extractor hood model.
a The fan is switched on.
Press
to switch off the fan.
3.
Switching on automatic mode
You can set automatic mode using the hob's control
panel.
Requirement: The function is assigned to Favourite
button.
To switch on automatic mode, press
1.
a The
display lights up.
To switch off automatic mode, press
2.
Setting the hood lighting
You can switch the hood light on and off using the
hob's control panel.
Requirement: The function is assigned to Favourite
button.
To switch the lighting on, press
1.
To switch the lighting off, press
2.
Fan off
Fan setting 1
Fan setting 2
Fan setting 3
Intensive mode 1
Intensive mode 2
Automatic mode
.
.
.
again.