ActronAir LM7-2G Panduan Petunjuk Instalasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Pendingin Udara ActronAir LM7-2G. ActronAir LM7-2G 8 halaman. Wall controller

Halaman Cetak

1. 05. Enabling / Disabling Zones and Assigning Sensors

Installation Guide

3. Mount back cover to the wall

• Mount the back cover to the wall with screws via screw

holes. If required, the use of a plasterboard mounting

bracket is recommended to mount the back cover to the

wall.

• Ensure that the Control Interface back cover is aligned

and leveled on the wall before tightening the screws.

BACK COVER

PLASTERBOARD

MOUNTING BRACKET

SCREW HOLES

5. Attach PCB casing to the back cover

• Attach the PCB casing by aligning with the back cover

mounted on the wall.

• Ensure the PCB casing makes a 'click' sound after

mounting.

BACK COVER

7. Assign and attach zones

• Attach the desired zone buttons and assign names to

each zone.

• Ensure the buttons make a 'click' sound when attached

to the PCB casing.

PCB CASING

BACK COVER

NOTE

Front cover can be removed even after installation. Press at

the bottom of the control interface and pull the front cover.

PCB CASING

ZONE BUTTONS

LM7-LM24 Control Interface Insert

Doc. No. 9590-3025 Ver. 2 220907

LM7-LM24 Control Interface

4. Connect wiring at the back of Control Interface

• Ensure that all wiring is tightly connected. All wiring must

be in accordance with the provided wiring diagram.

DO NOT CONNECT TRACE WIRE TO

WALL CONTROLLER.

CUT WIRE TO PREVENT SHORTING OUT.

6. Select zone buttons

• Remove the relevant zone buttons for zone name to be

allocated

8. Attach the front cover, as shown in the diagram below

IMPORTANT

Ensure protective film is removed from inside of the front

cover before attaching.

• On completion of the mounting installation, check that the

Control Interface is aligned and leveled on the wall.

BACK COVER

AS MOUNTED

ON THE WALL

SENSOR

KEY

COMMON

POWER

BUTTON PAD

FRONT COVER