Ricoh Pro L4160 Manual Cetak - Halaman 4
Jelajahi secara online atau unduh pdf Manual Cetak untuk Printer Ricoh Pro L4160. Ricoh Pro L4160 8 halaman. Wide format color digital imaging system
Juga untuk Ricoh Pro L4160: Tindakan Pencegahan Keselamatan (17 halaman), Spesifikasi (4 halaman), Panduan Perawatan dan Pemeliharaan (29 halaman)
Prepare the RICOH Software RIP
Check that the attached software RIP [RICOH Software RIP] is prepared.
1.
Check if the attached RICOH Software RIP is installed.
• If it is installed, the icon on the right is displayed on the PC desktop.
• For the installation, refer to
RICOH Software
2.
Check the connection with RICOH Pro L4130/L4160.
(1) Is the power supply of RICOH Pro L4130/L4160 turned ON?
(2) Is the PC in whichthe attached RICOH Software RIP is installed connected with RICOH Pro
L4130/L4160?
3.
Register the printer in the attached RICOH Software RIP.
• For print in RICOH Pro L4130/L4160, the registration of the printer into the attached RICOH
Software RIP is required.
• If you have already registered a printer, you can skip this step. Proceed to
(1) Double click
• The main window of the RICOH Software RIP is displayed.
• If no printer is registered, the [Printer Management...] window appears. In this case, pro-
(2) From the menu, select [Environments], and then
[Printer Management...].
• The [Printer Management...] window appears.
(3) Click [Add].
• The [Printer setting]window appears.
(4) Set the printer information.
(The setup procedure described below assumes
that RICOH Pro L4160 is connected. Set the
printer information in the following order:)
• Output Port
• Available Printers : Select Pro L4160.
• Model
• Color
• Printer Name
(For an ink set, the information retrieved from
the printer is displayed.)
(5) Click [OK].
• The confirmation screen is displayed.
Clicking [OK] starts the registration of the
printer.
• The [Do you create the hot folder and printer
driver?] confirmation window appears. If you
want to create them, click [Yes]. (You can also
create them at a later time.)
RIP.
to start the RICOH Software RIP.
ceed to step (3).
: USB2.0
: RICOHProL4000
: Select depending on the
device.
: Enter "4160".
Installation Guide of the attached
- 4 -
"Perform
printing".