Cisco 3640 Series Panduan Pengguna - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Router Jaringan Cisco 3640 Series. Cisco 3640 Series 26 halaman. Rack-mount and wall-mount
Juga untuk Cisco 3640 Series: Panduan Instalasi (10 halaman), Panduan Pemilik (17 halaman), Panduan Memulai Cepat (37 halaman), Manual (10 halaman), Catatan Konfigurasi (18 halaman)

Halaman Cetak
Cisco 3640 Series Panduan Pengguna
Configuration Tasks
Step
13
14
15
16
17
18
19
20
21
22
6
Cisco IOS Release 12.0(3)T
Command
Router(config-if)#isdn spid1 spid-number
[ ldn ]
Router(config-if)#isdn spid2 spid-number
[ ldn ]
Router(config-if)#isdn caller number
Router(config-if)#isdn answer1
[ called-party-number ]
[: subaddress ]
Router(config-if)#isdn calling-number
calling-number
Router(config-if)#isdn not-end-to-end
|
]
64
Router(config-if)#isdn incoming-voice
modem
Router(config-if)#isdn modem-busy-cause
{ number | busy | not available}
Router(config-if)#isdn
fast-rollover-delay seconds
Router(config-if)#isdn sending-complete
Purpose
Specify a SPID and local directory
number for the B1 channel. Currently,
only the DMS-100 and NI-1 switch
types require SPIDs. Although the
5ESS switch type might support a
SPID, we recommend that you set up
that ISDN service without SPIDs.
Specify a SPID and local directory
number for the B2 channel.
(Optional) Configure caller ID
screening.
(Optional) Configure called-party
number verification for a called-party
number or subaddress number in the
incoming setup message.
(Optional) Specify the calling-party
number.
[
(Optional) Configure the speed for
56
incoming calls not recognized as ISDN
end-to-end.
Route incoming voice calls to the
modem and treat them as analog data.
This step is required for the Modem
over ISDN BRI feature.
(Optional) Specify the message that is
returned when no modem is available
for a call. This command is optional for
the Modem over ISDN BRI feature.
number is a 1- to 3-digit number. Valid
values are from 1 to 127, denoting a
Q.931 error cause code.
busy specifies that the message will be
"USER BUSY" when modems are
unavailable.
not available specifies that the message
will be "CHANNEL NOT
AVAILABLE" when modems are
unavailable.
(Optional) Configure a fast rollover
delay.
(Optional) Configure the BRI interface
to include the Sending Complete
information element in the outgoing
call Setup message. Used in some
geographic locations, such as Hong
Kong and Taiwan, where the sending
complete information element is
required in the outgoing call setup
message.