Cisco 3800 Series Mengkonfigurasi - Halaman 3

Jelajahi secara online atau unduh pdf Mengkonfigurasi untuk Router Jaringan Cisco 3800 Series. Cisco 3800 Series 32 halaman. Password recovery procedure
Juga untuk Cisco 3800 Series: Lembar data (8 halaman), Catatan Aplikasi (41 halaman), Panduan Pemecahan Masalah (15 halaman), Lembar data (20 halaman), Panduan Memulai Cepat (40 halaman), Panduan Pengguna (7 halaman)

Configuring Radio Settings on an Access Point

You can use the data rate settings to set up an AP to serve client devices operating at specific data rates.

For example, to set up the 2.4-GHz radio for 11 megabits per second (Mbps) service only, set the

11-Mbps rate to Basic and set the other data rates to Enabled. To set up the AP to serve only client

devices operating at 1 and 2 Mbps, set 1 and 2 to Basic and set the rest of the data rates to Enabled. To

set up the 5-GHz radio for 54 Mbps service only, set the 54-Mbps rate to Basic and set the other data

rates to Enabled.

You can also configure the AP to set the data rates automatically to optimize either range or throughput.

When you enter range for the data rate setting, the AP sets the 1 Mbps rate to basic and the other rates

to enabled. When you enter throughput for the data rate setting, the AP sets all four data rates to basic.

Universal client mode is a wireless radio station role that allows the radio to act as a wireless client to

another access point or repeater. This feature is exclusive to the integrated radio running in the

Cisco 870, 1800, 2800, and 3800 integrated service routers (ISRs).

Universal client mode has the following features and limitations:

•

How to Configure Radio Settings on an Access Point

This section contains the following tasks:

•

You can configure universal client mode on the main dot11radio interface only, subinterfaces are

not supported.

Universal client can associate to access points with radio VLANs.

Layer-3 routing is supported over the radio interface. However, there is no support for layer 2 (L2)

bridging. The user cannot configure a dot11radio interface with a bridge-group when in universal

client mode.

Service Set Identifiers (SSIDs) are required to be configured on the dot11 interface operating as a

universal client; association to an access point running in guest mode is not supported.

The universal client can associate to Cisco access points, third party access points, and repeaters. It

cannot associate to Cisco root bridges or Cisco workgroup bridges.

Easy VPN does not support universal client mode using DHCP.

How to Configure Radio Settings on an Access Point

(optional)