Cisco 4500-M Panduan Instalasi - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Router Jaringan Cisco 4500-M. Cisco 4500-M 18 halaman. Upgrading memory
Juga untuk Cisco 4500-M: Manual Penggantian (16 halaman), Panduan Peningkatan (24 halaman)
Halaman Cetak
Preparing the Chassis for Rack-Mounting or Wall-Mounting
Step 7
Step 8
Removing the Component Tray from a Chassis without a Safety Latch
Warning
working near the power supply. Before starting any of these procedures, turn OFF power to the
system, unplug the power cord, disconnect any cables at the ports, and attach your ESD-preventive
wrist strap.
Take the following steps to remove the component tray from a chassis without a safety latch:
Step 1
Step 2
Step 3
Step 4
Warning
hands, to prevent it from falling.
Figure 3
Chassis shell
6 Cisco 4000 Series Rack-Mount and Wall-Mount Installation
Set the component tray on your work surface.
Remove the plastic front panel from the front of the chassis shell by pulling it straight out
using both hands.
Hazardous voltages may exist in or near the power supply, so use extreme caution when
Turn OFF the system power.
Attach your ESD-preventive wrist strap.
Remove all network and power cables.
Loosen the nonremovable screw in the back of the router chassis. The screw is labeled
"Chassis release screw" in Figure 3.
Support the component tray from underneath, either on your work surface or with your
Component Tray Removal for Chassis Without a Safety Latch
Rear of chassis
Chassis release
screw
AUX
CONSOLE
Support the component
tray with your hand
INPUT 100-240VAC
50/60HZ 3.0-1.5 AMPS
Handle