Cisco AIR-AP1020 - 1000 Series Lightweight Access Point Panduan Memulai Cepat - Halaman 35
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Titik Akses Nirkabel Cisco AIR-AP1020 - 1000 Series Lightweight Access Point. Cisco AIR-AP1020 - 1000 Series Lightweight Access Point 44 halaman. Aironet 1000 series ieee 802.11a/b/g lightweight access points with external antennas
Halaman CetakAppendix A
Planning Notes
About Mounting Options
Caution
Plenum-mounted Cisco Aironet 1000 Series 802.11a/b/g lightweight access points MUST BE powered
using PoE to comply with safety regulations.
Note
•
•
•
•
•
•
About Mounting Options
Note
•
•
AP1020/1030 Cisco Aironet 1000 Series IEEE 802.11a/b/g Lightweight Access Points with External Antennas - Quick Start Guide
78-17147-01
Because the Cisco Aironet 1000 Series lightweight access point internal antennas have been
designed to reduce inter-floor interference, it is strongly recommended that you mount the Cisco
Aironet 1000 Series lightweight access point standing or hanging straight up or down.
You can mount the Cisco Aironet 1000 Series 802.11a/b/g lightweight access points in the ceiling
plenum or below the ceiling using the ceiling mount base or wall mount brackets, but the Cisco
Aironet 1000 Series 802.11a/b/g lightweight access points perform best when mounted below the
ceiling.
External antennas are NOT to be used when installing Cisco Aironet 1000 Series 802.11a/b/g
lightweight access points in a plenum.
When you are mounting the Cisco Aironet 1000 Series lightweight access point in the middle of a
ceiling, ceiling plenum, or hallway, you will typically use the color-coordinated ceiling-mount base
to stabilize the Cisco Aironet 1000 Series lightweight access point after it is mounted. Use the
mounting base to mark the sheet metal, drywall, or other screw locations.
The mounting base attaches to the bottom of the Cisco Aironet 1000 Series lightweight access point
with two supplied screws, and then the assembly slides and locks onto two sheet metal, drywall, or
other screws.
When you are mounting the Cisco Aironet 1000 Series lightweight access point out from a wall (flat
sides along the room or hallway), use the projection-mount L-bracket supplied with the Cisco
Aironet 1000 Series lightweight access point. Use the L-bracket to mark the sheet metal, drywall,
or other screw locations.
When you are mounting the Cisco Aironet 1000 Series lightweight access point against a wall (flat
Side A toward the inside of the building), use the flush-mount bracket supplied with the Cisco
Aironet 1000 Series lightweight access point. The flush-mount L-bracket is the one with one long
and one short leg. Use the L-bracket to mark the sheet metal, drywall, or other screw locations.
Because the Cisco Aironet 1000 Series lightweight access point internal antennas have been
designed to reduce inter-floor interference, it is strongly recommended that you mount the Cisco
Aironet 1000 Series lightweight access point standing or hanging straight up or down.
You can mount the Cisco Aironet 1000 Series 802.11a/b/g lightweight access points in the ceiling
plenum or below the ceiling using the ceiling mount base or wall mount brackets, but the Cisco
Aironet 1000 Series 802.11a/b/g lightweight access points perform best when mounted below the
ceiling.
A-3