Argent E10SW1001 Petunjuk Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Perabotan Dalam Ruangan Argent E10SW1001. Argent E10SW1001 2 halaman. Element wall hung

Halaman Cetak

INSPECT THE FURNITURE TO

ENSURE NO DAMAGE HAS

OCCURRED DURING TRANSIT.

IF DAMAGE HAS OCCURRED,

OR VISIBLE DEFECTS EXIST,

D O N O T P R O C E E D W I T H

INSTALLATION AND ADVISE

ARGENT IMMEDIATELY.

FURNITURE MUST BE FITTED

THROUGH STUDS INTO THE

WALL. USE FIXING BRACKETS

PROVIDED.

IF STUD POSITIONING DOES

N O T A L I G N W I T H F I X I N G

BRACKETS, CABINET MUST

BE ADDITIONALLY SECURED

THROUGH THE BACK BOARD

TO STUDS. IF NO STUDS ARE

FOUND TO SECURE THROUGH,

NOGGINS MAY BE REQUIRED.

PRIOR TO INSTALLATION

Argent recommends a qualified trade

person fit your vanity. Ensure your

furniture is installed to relevant building

codes and Australian Standards.

Please note, Argent will not be liable

for the cost of installation or removal

of the furniture and the warranty will be

voided if damage occurred during or

after installation.

Fit wall hung basin at required height

to secure stud or frame, ensure level.

Fit plumbing.

(1)

Remove

the drawer units and fixings

from inside the vanity and set aside

carefully.

Hold vanity over pipes in correct position.

(2)

Use

scrap blocks of wood to set at

just under correct height.

MEASURE & MARK

(3)

Find

in wall studs to secure to. Measure and mark

position for drilling. Fix through a stud where possible.

If no studs are found to secure through, special fixings

may be required. Use fixings appropriate to your wall

material.

FIT OFF, ADJUST & FINISH

Drill securing screws appropriate to your wall through

furniture back board into stud and wall.

Replace drawer adjust to ensure all square with the

installed vanity.

Put a bead of waterproof mastic compound around the

back edge of the basin and where the basin touches the

wall. Do not over tighten the basin bolts, to avoid

damaging the basin.

Ensure drawers are adjusted to sit

square as they may have moved

during transportation. Ensure runners

are locked in place.

Drawer Adjustment

Feel under the drawer for release

catches. Squeeze catches, lift up

and towards you to release the

drawer from the runners.

Basin Sealing

I MP OR TA N T:

U S E ON LY b a th ro o m

g rad e si l i co n s ea l an t

Epoxy type glues

MUST NOT BE USED.

Put a bead of waterproof mastic

compound around the back

edge of the basin and where the

basin touches the wall. Do not

tighten the basin bolts to avoid

damaging the basin.

I M P OR TA N T:

INSPECT THE FURNITURE

TO ENSURE NO DAMAGE

HAS OCCURRED DURING

TRANSIT.

IF DAMAGE HAS

OCCURRED, OR VISIBLE

DEFECTS EXIST, DO

NOT PROCEED WITH

INSTALLATION AND ADVISE

ARGENT IMMEDIATELY.