Cisco TelePresence System C20 Plus Panduan Memulai - Halaman 30
Jelajahi secara online atau unduh pdf Panduan Memulai untuk Sistem Konferensi Cisco TelePresence System C20 Plus. Cisco TelePresence System C20 Plus 35 halaman. Telepresence conference system
Juga untuk Cisco TelePresence System C20 Plus: Panduan Pengguna (44 halaman), Panduan Memulai (32 halaman), Panduan Memulai (46 halaman)
Halaman Cetak
Cisco TelePresence Systems
GettinG started Guide
Table of contents
Introduction
Web interface
Setting the system/codec password
You need a username and password to sign in to the web
and command line interfaces of your system.
The video conference system is delivered with a default
user account with username
admin
and no password set.
This user has full access rights to the system.
NOTE: We strongly recommend that you set a password for
the
admin
user to restrict access to system configuration.
Make sure to keep a copy of the password in a safe
You have to contact your Cisco representative if you have
forgotten the password.
1. Go to the
Maintenance
tab and select
2. Enter the
Current
password, the
New
repeat the new password in the appropriate input fields.
The password format is a string with 0–64 characters.
If a password is not currently set, use a blank
password.
3. Click
Change
password.
D14639.04 Video Systems Getting Started Guide (TC4.2) | 2011 JULY | © 2011 Cisco Systems, Inc. All rights reserved.
User interfaces
Setting the Administrator Settings menu
password
When starting up the system for the first time the
Administrator Settings menu password is not set.
NOTE: We strongly recommend that you define a password
to protect the Administrator Settings menu, since these
settings affect the behavior of the video conference system.
The Administrator Settings menu password cannot be
set via the web interface. This has to be done using the
place.
command line interface or the remote control and on‑
screen menu.
Set the Administrator Settings menu password from
Change
Password.
a command line interface
password, and
1. Connect to the system through the network or the
serial data port, using a command line interface (SSH or
Telnet).
Current
2. Type the following command:
xCommand SystemUnit MenuPassword Set
Password: <password>
The password format is a string with 0–255 characters.
Set the Administrator Settings menu password
using the remote control and on-screen menu
1. Go to
Home > Settings > Administrator Settings > Set
menu
password.
On the remote control, press the # key to toggle
between lower or upper case characters and numbers:
abc/ABC/123.
2. Enter the menu password. The password you enter is
hidden; each character is replaced with a star (*).
3. Select Save to save the changes, or Cancel to leave
without saving.
4. Press
Home
Configuration
Configuration
Appendices
(
)
to exit.
30
www.cisco.com