Cisco PIX 506E Panduan Memulai Cepat - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco PIX 506E. Cisco PIX 506E 18 halaman. Chapter 3
Juga untuk Cisco PIX 506E: Panduan Memulai Cepat (17 halaman), Panduan Pengguna (8 halaman)

Halaman Cetak
Cisco PIX 506E Panduan Memulai Cepat
PDM version 2.0 and higher releases include a Startup Wizard for initial configuration. Follow these steps
to load PDM and use the Startup Wizard:
Use an Ethernet cable to connect your PC to the inside port (Ethernet 1) on the rear panel of
Step 1
the PIX Firewall.
Configure your PC to use DHCP (to receive an IP address automatically from the
Step 2
PIX Firewall) or assign a static IP address to your PC by selecting an address out of the
192.168.1.0 network.
The inside interface of the PIX Firewall is assigned 192.168.1.1, so choose a different
Note
IP address.
Check the ACT LED on the rear panel of the PIX Firewall (see Table 2 on page 6) to verify
Step 3
that your PC has basic connectivity to the inside port (Ethernet 1). When connectivity occurs,
the ACT LED next to the port lights up solid green.
To access the Startup Wizard, use a PC connected to the inside port and enter the URL
Step 4
https://192.168.1.1/startup.html into your browser.
It is very important to enter the "s" in "https://192.168.1.1," which indicates
Note
a secure connection. If you enter "http://192.168.1.1" without the "s" in
"https," you cannot access the PIX Firewall.
Accept the certificates and follow the instructions in the Startup Wizard. For online help, click
Step 5
the Help button at the bottom of the Startup Wizard window.
9