Cisco Rack-Mount and Cable Mgmt. 7505/7010 Panduan Petunjuk Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Perangkat Keras Jaringan Cisco Rack-Mount and Cable Mgmt. 7505/7010. Cisco Rack-Mount and Cable Mgmt. 7505/7010 15 halaman. Rack-mount and cable management kits
Halaman Cetak
Product Overview
Product Overview
The Cisco 7010 is the five-slot model in the Cisco 7000 series product line and the Cisco 7505 is the
five-slot model in the Cisco 7500 series. Figure 1 shows the interface processor end of the Cisco
7010 chassis.
Note
the same.
The interface processor end of the chassis contains the processor slots, the AC power receptacle (a
DC-input power supply is available, but not shown), the power switch, the DC OK status LED, and
a screw for a chassis ground connection. The noninterface processor end of the chassis is a
removable panel (secured with two captive slotted screws) that provides access to the internal
components. For a complete description of the chassis, refer to the Cisco 7010 Hardware
Installation and Maintenance or Cisco 7505 Hardware Installation and Maintenance publications.
Figure 1
On/off
power switch
You can mount the chassis in most standard 19-inch or Telco-type equipment racks, with either end
of the chassis at the front of the rack. Ideally, you should be able to access both ends of the router
without having to remove it from the rack. Because the interface processor end provides access to
the power switch, processor slots, and all status LEDs, we recommend that you mount the router
with the interface processor end at the front, or most accessible side, of the rack.
The rack-mount kit comprises two chassis ears that attach to the sides of the chassis at either the
interface processor or noninterface processor end, four fasteners to secure the ears to the chassis, and
eight fasteners to secure the ears to the mounting strips or posts on the equipment rack.
2 Cisco 7010 and Cisco 7505 Rack-Mount and Cable Management Kits Installation Instructions
For the procedures in this publication, the Cisco 7010 and Cisco 7505 chassis are functionally
Noninterface Processor End of the Cisco 7010 Chassis
AC power
receptacle
Chassis
ground
DC OK
power indicator
Power supply