Cisco UBR7246VXR Instalasi Perangkat Keras - Halaman 10
Jelajahi secara online atau unduh pdf Instalasi Perangkat Keras untuk Perangkat Keras Jaringan Cisco UBR7246VXR. Cisco UBR7246VXR 25 halaman. Universal broadband router
Juga untuk Cisco UBR7246VXR: Panduan Memulai Cepat (27 halaman), Panduan Pengguna (7 halaman), Panduan Instalasi (28 halaman)
Halaman Cetak
Figure 5
Installing the Rack-Mount Brackets so the Front of the Chassis Is Flush with the Rack
Rack-mount bracket
Note
You cannot use the cable management bracket in this configuration.
Figure 6
Installing the Rack-Mount Brackets so the Front of the Chassis Protrudes Out of the Rack
Rack-mount bracket
Attach the Rack-Mount Brackets to the Middle of the Chassis
To install the rack-mount brackets for an open or relay-type rack-mount configurations, complete the following steps:
Step 1
Locate the threaded holes in the middle sides of the chassis.
Step 2
Align the first rack-mount bracket to the threaded holes in the right side of the chassis, as shown in Figure 7. Use either
set of four holes to align the bracket to the threaded holes in the sides of the chassis.
Step 3
Thread the four M4 x 6-mm Phillips flathead screws through the rack-mount bracket and into the side of the chassis.
Use a number 2 Phillips screwdriver to tighten the screws.
Step 4
Repeat Step 1 through Step 3 to attach the other rack-mount bracket.
Step 5
See the "Installing the Cable-Management Brackets" section on page 11 for cable management bracket instructions.
10
Rack-mount bracket
Rack-mount bracket