Cisco UCS 5108 Manual - Halaman 4

Jelajahi secara online atau unduh pdf Manual untuk Perangkat Keras Jaringan Cisco UCS 5108. Cisco UCS 5108 8 halaman. Fnic tunables feature
Juga untuk Cisco UCS 5108: Lembar Spesifikasi (50 halaman)

Halaman Cetak

Table 1 lists the boot configuration capabilities of the supported operating systems .

Table 1 . Local Boot and Boot from SAN Configuration Capabilities by Operating System (X signifies available capability)

RHEL 5 .x, 6 .x – Local Boot

RHEL 5 .x, 6 .x – Boot from SAN

SLES 11 – Local Boot

SLES 11 – Boot from SAN

XS – Local Boot

XS – Boot from SAN

ESX 5 .x – Local Boot

ESX 5 .x – Boot from SAN

Displaying fnic_max_qdepth Parameter Value

The current and postconfiguration value of the fnic_max_qdepth parameter can be displayed using the following commands .

RHEL 6 .x / SLES11 / XS

1 . To display the current fnic_max_qdepth, run the following command:

# cat /sys/module/parameters/fnic_max_qdepth

2 . To display the current fnic_max_qdepth on a per-LUN basis, which is relevant if the value was changed using the run-time

configuration for newly discovered LUNs, run the following command at the command-line interface (CLI) (install lsscsi if

not already installed):

# lsscsi –l

ESX 5 .x

1 . From the ESX CLI, run the following command (the fnic_max_qdepth parameter will not be listed until it has been explicitly

set per the configuration instructions below):

# cat /etc/vmware/esx .conf |grep fnic

Results:

/vmkernel/module/fnic/options = fnic_max_qdepth=128

2 . From the ESX CLI, run the following esxcli command (the fnic_max_qdepth value will be empty until the fnic_max_qdepth

parameter has been explicitly set per the configuration instructions below):

# esxcli system module parameters list –m fnic

Results:

Name

---------------

----

fnic_max_qdepth

uint 128

Boot Time

Type

Value

Description

-----

----------------------------------

Queue depth to report for each LUN

Load Time

Run Time