Cisco Firepower 2130 Memulai - Halaman 28
Jelajahi secara online atau unduh pdf Memulai untuk Server Cisco Firepower 2130. Cisco Firepower 2130 42 halaman. Rack-mount and ground the chassis
Juga untuk Cisco Firepower 2130: Manual (12 halaman), Panduan Penyebaran (8 halaman), Instalasi & Pemeliharaan (26 halaman)
Halaman Cetak
Default Configuration Prior to Initial Setup
Setting
Outside interface IP address.
Default Interfaces by Device Model
You cannot select different inside and outside interfaces during initial configuration. To change the interface
assignments after configuration, edit the interface and DHCP settings. You must remove an interface from
the bridge group before you can configure it as a non-switched interface.
FTD device
Firepower 1010
Firepower 1120, 1140, 1150
Firepower 2100 series
Secure Firewall 3100 series
Firepower 4100 series
Firepower 9300 appliance
FTDv
ISA 3000
Getting Started
28
Default
IPv4: Obtained through DHCP from
Internet Service Provider (ISP) or upstream
router.
IPv6: Autoconfiguration.
Firepower 4100/9300: Data interfaces are
not pre-configured.
ISA 3000: BVI1 IP address is not
preconfigured. BVI1 includes all inside and
outside interfaces.
Outside Interface
Ethernet1/1
Ethernet1/1
Ethernet1/1
Ethernet1/1
Data interfaces are not pre-configured.
Data interfaces are not pre-configured.
GigabitEthernet0/0
GigabitEthernet1/1 and GigabitEthernet1/3
GigabitEthernet1/1 (outside1) and 1/2
(inside1), and GigabitEthernet1/3 (outside2)
and 1/4 (inside2) (non-fiber models only)
are configured as Hardware Bypass pairs.
All inside and outside interfaces are part of
BVI1.
Can be changed during initial
configuration?
Yes.
Inside Interface
VLAN1, which includes all other switch
ports except the outside interface, which is
a physical firewall interface.
Ethernet1/2
Ethernet1/2
Ethernet1/2
Data interfaces are not pre-configured.
Data interfaces are not pre-configured.
GigabitEthernet0/1
GigabitEthernet1/2 and GigabitEthernet1/4
Getting Started