Cisco UCS B420 M4 Catatan Instalasi dan Layanan - Halaman 22

Jelajahi secara online atau unduh pdf Catatan Instalasi dan Layanan untuk Server Cisco UCS B420 M4. Cisco UCS B420 M4 38 halaman. Blade server

Upgrading to Intel Xeon E5-4600 v4 Series CPUs

Before upgrading to Intel Xeon E5-4600 v4 Series CPUs, ensure that the server is running the required

minimum software and firmware versions that support Intel E5-4600 v4 Series CPUs, as listed in the following

table.

Software or Firmware

Cisco UCS Manager

Cisco IMC

BIOS

Note

Cisco UCS Manager Release 2.2(4) introduced a server pack feature that allows Intel E5-4600 v4 CPUs to

run with Cisco UCS Manager Release 2.2(4) or later, provided that the Cisco IMC, BIOS and Capability

Catalog are all running Release 2.2(8) or later.

Caution

Ensure that the server is running the required software and firmware before installing the Intel E5-4600 v4

Series CPUs. Failure to do so can result in a non-bootable CPU.

Do one of the following actions:

• If the server software and firmware are already at the required minimum version as shown in the preceding

• If the server software or firmware is not at the required minimum version, follow the instructions in the

Procedure

Step 1

Unscrew the four captive screws.

Step 2

Remove the heat sink.

Cisco UCS B420 M4 Blade Server Installation and Service Note

table, replace the CPUs by using the procedure in the following section.

Cisco UCS B420 M4 Server Upgrade Guide for E5-4600 v4 Series CPUs

the CPUs by using the procedure in the following section.

Minimum Version

Release 3.1(2) or Release 2.2(8) (See the following Note for additional

supported versions.)

Release 3.1(2) or Release 2.2(8)

Servicing the Blade Server

to upgrade it. Then replace