Cisco VCS Memulai - Halaman 4

Jelajahi secara online atau unduh pdf Memulai untuk Server Cisco VCS. Cisco VCS 12 halaman. Telepresence video communication server

Installing the Cisco VCS

To avoid damage to the unit during transportation the Cisco VCS is delivered in a special shipping box,

which should contain the following components:

Cisco VCS unit

rack ears, screws and Torx driver

rubber feet

cables:

power cables

Ethernet cable

shielded serial cable

Report any discrepancies to your Cisco representative immediately.

We recommend that the shipping box is kept in case the Cisco VCS needs to be returned.

IMPORTANT: Before installing the Cisco VCS, you must read the safety information at

www.cisco.com/go/telepresence/safety.

Before installing the Cisco VCS:

Ensure that the Cisco VCS is accessible and that all cables can be easily connected.

Ensure that the power outlet is near to the Cisco VCS and is easily accessible.

To ensure adequate ventilation, leave a space of at least 10cm (4 inches) behind the VCS's rear

panel and 10cm (4 inches) in front of the front panel.

The room in which you install the Cisco VCS should have an ambient temperature between 0ºC and

35ºC (32ºF and 95ºF) and between 10% and 90% non-condensing relative humidity.

Use a grounded AC power outlet for the Cisco VCS.

1. Unpack the unit.

2. Mount the rack ears (using a Torx T10 driver) or rubber feet.

3. Turn the unit back on its feet or mount it in the rack.

If this product is mounted in a rack you are recommended to use additional support

accessories such as rack side support angles (rack angle brackets) or rack shelves, due to

the unit's weight and depth. Contact your rack supplier to request the accessories best

suited for your rack.

1. Connect the power cable to the back of the Cisco VCS (see Figure 1).

2. Connect the Ethernet LAN cable from the LAN1 port on the front of the Cisco VCS to your network

(see Figure 2).

VCS Getting Started Guide

Installing the Cisco VCS

Page 4 of 12