Cisco ASR 5000 Panduan Instalasi - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Gerbang Cisco ASR 5000. Cisco ASR 5000 37 halaman. Applying power and verifying the installation
Juga untuk Cisco ASR 5000: Panduan Instalasi (18 halaman), Panduan Instalasi (33 halaman), Prosedur Instalasi (8 halaman)
Halaman Cetak
Checking the LEDs on Packet Processing Cards
Table 8: Packet Processing Card Run/Fail LED States
Color
Green
Blinking
Green
Red
None
PSCA, PSC2, PSC3 and PPC Active LED States
The Active LED on the packet processing card indicates that the software is loaded on the card and that the
card is ready for operation. When the system first boots up, all installed packet processing cards are booted
into standby mode. You must then configure the system to designate which packet processing cards are to
serve as redundant components (in standby mode) and which are to function as active components.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 9: Packet Processing Card Active LED States
Color
Green
ASR 5000 Installation Guide
14
Description
Troubleshooting
Card powered with no
None needed.
errors detected
Card is initializing and/or
None needed.
loading software
Card powered with
Errors were detected during the POSTs. It is likely that the errors
error(s) detected
were logged to the system's command line interface during the
boot process.
Card is not receiving
Verify that the POWER LEDs on the PFUs are green. If they are
power
not, refer to
troubleshooting information.
Verify that the power source is supplying ample voltage and
current to the chassis.
Verify that the card is properly installed per the instructions in
this document.
If all of the above suggestions have been verified, it is possible
that the packet processing card is not functional. Please contact
your service representative.
Description
Troubleshooting
Card is active
The first time power is applied to the system, all of the packet
processing cards should be booted into the standby mode.
Therefore, this LED should be off.
Applying Power and Verifying the Installation
Checking the LED on the PFU, on page 5
for