Cisco VG202 Panduan Konfigurasi Perangkat Lunak - Halaman 18
Jelajahi secara online atau unduh pdf Panduan Konfigurasi Perangkat Lunak untuk Gerbang Cisco VG202. Cisco VG202 50 halaman. Voice gateways
Juga untuk Cisco VG202: Panduan Pemasangan Perangkat Keras (50 halaman), Manual (10 halaman), Panduan Pemasangan Perangkat Keras (48 halaman), Panduan Memulai Cepat (19 halaman)
Halaman Cetak
Configuring Global Parameters
Configuring global parameters:
Enter hostname [VG]: VG204
The enable secret is a password used to protect access to privileged EXEC and
configuration modes. This password, after entered, becomes encrypted in the configuration.
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 5
viewing the configuration:
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: cisco
Enter an enable password that is different from the enable secret password. This password is not
Step 6
encrypted (less secure) and can be seen when viewing the configuration:
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: cisco
% Please choose a password that is different from the enable secret
Enter enable password: cisco
Enter the virtual terminal password, which prevents unauthenticated access to the VG through ports
Step 7
other than the console port:
The virtual terminal password is used to protect
access to the VG over a network interface.
Enter virtual terminal password: cisco
Configure SNMP Network Management? [yes]: n
Configure IP? [yes]:
Configure RIP routing? [yes]: n
Configure bridging? [no]:
Respond to the following prompts as appropriate for your network:
Step 8
Do you want to configure FastEthernet0/0
Use the 100 Base-TX (RJ-45) connector? [yes]:
Operate in full-duplex mode? [no]:
Configure IP on this interface? [yes]:
IP address for this interface: 9.13.38.150
Subnet mask for this interface [255.0.0.0] : 255.255.255.0
Class A network is 9.0.0.0, 24 subnet bits; mask is /24
Do you want to configure FastEthernet0/1
Would you like to go through AutoSecure configuration? [yes]: n
AutoSecure dialog can be started later using "auto secure" CLI
The following configuration command script was created:
hostname VG-202
enable secret 5 $1$Y0VQ$D8qM6vS3qId.BP3w.GjlE.
enable password cisco
line vty 0 4
password cisco
no snmp-server
!
ip routing
no bridge 1
Cisco VG202 and Cisco VG204 Voice Gateways Software Configuration Guide
2-4
Chapter 2
interface? [yes]:
interface? [yes]: n
Using the setup Command Facility
OL-16191-01