Cisco VG202 Panduan Pemasangan Perangkat Keras - Halaman 46
Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Gerbang Cisco VG202. Cisco VG202 50 halaman. Voice gateways
Juga untuk Cisco VG202: Panduan Konfigurasi Perangkat Lunak (50 halaman), Manual (10 halaman), Panduan Pemasangan Perangkat Keras (48 halaman), Panduan Memulai Cepat (19 halaman)
Halaman Cetak
Troubleshooting
Verify the initial configuration. See the
Step 13
for verification procedures.
Manual Configuration
To configure the Cisco VG202 or Cisco VG204 from a console (locally or remotely), see the
Cisco VG202 and Cisco VG204 Voice Gateways Feature Module
For information about obtaining any referenced documentation, see the
Submitting a Service Request" section on page
Verifying and Saving Your Configuration
To verify the configuration and save it in NVRAM so that the configuration remains in effect if the
Cisco VG202 or Cisco VG204 voice gateway is restarted, enter the following commands:
Command
Step 1
VG# show running-config
Step 2
VG# show startup-config
Step 3
VG# copy running-config startup-config
Troubleshooting
This section describes possible mechanical problems and corrective actions.
If there appears to be a malfunction, first check all cables and connections. If these are in order, see
Table 4-1
For problems with the configuration, see the
Module
Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide
4-6
for specific troubles and solutions.
for configuration instructions.
Chapter 4
Powering On the Cisco VG202 and Cisco VG204 Voice Gateways
"Verifying and Saving Your Configuration" section on page 4-6
xvi.
Purpose
Displays the current operating configuration, including any
changes you have just made.
Displays the configuration currently stored in NVRAM.
Writes the current running configuration to NVRAM, where it
overwrites the startup configuration and becomes the new startup
configuration.
If you reboot the Cisco VG202 or Cisco VG204 voice
Note
gateway or turn off the power before you complete this
step, you lose the configuration.
Cisco VG202 and Cisco VG204 Voice Gateways Feature
for configuration instructions.
"Obtaining Documentation and
OL-15959-01