Epson FX-880+ Panduan Cepat - Halaman 27
Jelajahi secara online atau unduh pdf Panduan Cepat untuk Aksesori Printer Epson FX-880+. Epson FX-880+ 33 halaman. Epson serial impact dot matrix printers
Juga untuk Epson FX-880+: Setup Manual (33 halaman), Brosur & Spesifikasi (24 halaman), Manual (18 halaman), Spesifikasi (2 halaman), Baca Ini Terlebih Dahulu (2 halaman), Panduan Referensi (34 halaman)
Halaman Cetak
Micro Adjust Function
The Micro Adjust function allows you to
move the paper forward or backward in
0.118 mm (1/216-inch) increments so that
you can make precise adjustments to the
top-of-form and tear-off positions.
Adjusting the tear-off position
If your paper's perforation is not aligned
with the tear-off edge, you can use the Micro
Adjust function to move the perforation to
the tear-off position.
Follow these steps to adjust the tear-off
position:
c
Caution:
Never use the knob to adjust the tear-off
position; this may damage the printer or
cause it to lose the tear-off position.
Note:
Your tear-off position setting remains in effect
until you change it, even if you turn off the
printer.
1. Make sure the Tear Off/Bin light is
flashing (the paper is at the current
tear-off position). You may need to press
the Tear Off/Bin button to advance the
paper to the tear-off position.
Downloaded from:
http://www.usersmanualguide.com/
EPSON FX-880+/FX-1180+ Quick Guide
2. Hold down the Pause button for about
three seconds. The Pause light begins
flashing and the printer enters the Micro
Adjust mode.
3. Press the LF/FF D button to feed paper
backward, or press the Load/Eject U
button to feed paper forward, until the
paper perforation is aligned with the
tear-off edge of the printer cover.
1. tear-off edge of the printer cover
2. paper perforation
Note:
The printer has a minimum and a maximum
tear-off position. If you try to adjust the
tear-off position beyond these limits, the
printer beeps and stops moving the paper.
4. Tear off the printed pages.
5. Press the Pause button to turn off Micro
Adjust mode.
When you resume printing, the printer
automatically feeds the paper back to the
top-of-form position and begins printing.
Micro Adjust Function (1/2)