Epson LQ-590 Panduan Pengguna - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Aksesori Printer Epson LQ-590. Epson LQ-590 48 halaman. 24pin dot matrix printers
Juga untuk Epson LQ-590: Manual (11 halaman), Referensi Cepat (12 halaman), Ringkasan Teknis (7 halaman), Spesifikasi (2 halaman), Spesifikasi (2 halaman), Spesifikasi (4 halaman), Mulai di sini (2 halaman)

Halaman Cetak

Slide the left sprocket

approximately 0.5 inch

(12 mm) from the far

left position and push

the blue lever back to

lock it in place. Then

slide the right sprocket

to match the width of

your paper, but do not

lock it.

The triangle mark on top of the printer indicates the point furthest to

the left where printing can begin.

Make sure your paper

has a clean, straight

edge. Then open both

sprocket covers and fit

the first four holes of

the paper, with the

printable side down,

over the tractor pins.

Close the sprocket covers. Then slide the right sprocket to remove

any slack in the paper and lock it in place by pushing the blue lock

lever down.

Attach the paper guide and lay it flat on the printer. Slide the edge

guides to the middle of the paper guide.

Turn on the printer. When the printer receives data, it automatically

loads the paper and starts printing.

If the first line on your page appears too high or low, change its position

with the Micro Adjust function. (See page 33.)

Caution:

Never use the knob to adjust the top-of-form position; this may damage the

printer or cause it to lose the top-of-form position.

Paper Handling