Acuity Controls ECLYPSE A1000 Panduan Instalasi - Halaman 9

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Relai Acuity Controls ECLYPSE A1000. Acuity Controls ECLYPSE A1000 10 halaman. Asset tracking
Juga untuk Acuity Controls ECLYPSE A1000: Panduan Instalasi (14 halaman)

Halaman Cetak

Acuity Controls ECLYPSE A1000 Panduan Instalasi

1. Power Supply Information

6.0 - Additional Information

6.3 North American Emissions Compliance

United States

Changes or modifications not expressly approved by

Acuity could void the user's authority to operate the

equipment.

This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential and commercial installation. This equipment

generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio

or television reception, which can be determined by

turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

receiver.

Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician

for help.

7.0 - Sub-gigahertz Assets Adapter Mounting

Instructions

7.1 Typical Mounting Scenarios

The Sub-gigahertz Assets Adapter is typically mounted

in one of three common scenarios, these include:

•

Suspended Ceiling Mount

•

Mounting Bracket

•

Metal Panel/Utility Box

Whichever mounting scenario is chosen, the Assets

Adapter should be 16" (41 cm) or more away from any

network communication devices and not too close to the

actual ECLYPSE A1000AT. The Assets Adapter

connects directly to the ECLYPSE via the USB port. You

are supplied with a 16' cable. This cable cannot be made

any longer and must not be modified.

Canada

This Class (B) digital apparatus meets all the require-

ments of the Canadian Interference-Causing Equipment

Regulations.

Cet appareil numérique de la Classe (B) respecte toutes

les exigences du Règlement sur le matériel brouilleur du

Canada.

7.2 Instructions for Ceiling Mount

1. Use .875" (22mm) hole saw to create a mounting

hole position.

2. Disassemble the Assets Adapter: Unbox the

adapter, remove nut from the adapter, make sure

the gasket is on the adapter.

3. Place device in ceiling panel, place nut onto the USB

cable and hand tighten nut to the ceiling panel.

4. Connect the USB cable assembly's USB jack to one

of the controller's Host USB ports.

See Figure 14 on the following page for illustration.

A1000AT_IG_10_EN

9 of 10