Motorola EASE35-3 Panduan Pengguna - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Monitor Bayi Motorola EASE35-3. Motorola EASE35-3 27 halaman. 5" video baby monitor

7. Help

Display

No display

• Try recharging the battery pack.

• Reset the Units. Unplug both the Units' electrical power, then plug

them back in.

• Is the Unit switched on?

• Press and hold the ON/OFF button 0 on the Parent Unit for 3

seconds to switch it ON.

• Is the correct camera selected? Change the camera number, if

necessary.

• Is the video display turned on? Press the VIDEO ON/OFF button

V to turn it ON.

• When operating using batteries only, the display will go blank after

5 minutes or 30 minutes or 60 minutes to save power (depending

on video settings). The Unit is still active and will give you audio

alerts. You can reactivate the screen by pressing any button.

Registration

If the Baby Unit has lost its link with the Parent Unit

• If the Baby Unit is too far away it may be going out of range, so

move the Baby Unit closer to the Parent Unit.

• Reset both the Parent Unit and Baby Unit by disconnecting

them from the electrical power. Wait about 15 seconds before

reconnecting. Allow up to one minute for the Baby Unit and the

Parent Unit to synchronize.

• See 2.3 Registration (Pairing), if there is a need to re-register the

Units.

Interference

Noise interference on your Parent Unit

• Your Baby and Parent Units may be too close. Move them further

apart.

• Make sure there is at least 1 to 2m between the 2 Units to avoid

audio feedback.

• lf the Baby Unit is too far away, it may be out of range. Move the

Baby Unit closer to the Parent Unit.

Help