Motorola CLP series Panduan Pengguna - Halaman 36
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Radio Motorola CLP series. Motorola CLP series 48 halaman. By wsi
Juga untuk Motorola CLP series: Panduan Referensi Cepat (2 halaman), Referensi Cepat (2 halaman), Referensi Cepat (35 halaman), Panduan Pemecahan Masalah (2 halaman)
Halaman Cetak
68012000044-ED
Chapter 7 : Troubleshooting
If...
Message not transmitted or received
Heavy static or interference
Low batteries
Drop-in Charger LED light does not blink
Cannot activate VOX
36
Then...
age in industrial and commercial build-
ings. Increasing power provides greater
signal range and increased penetration
through obstructions.
Perform one of the following actions:
•
Ensure the PTT button is completely
pressed when transmitting.
•
Confirm that the radios have the
same Channel, Frequency, Interfer-
ence Eliminator Code, and Scramble
Code settings. See
Transmitting and Re-
ceiving on page
15.
•
Recharge, replace, or reposition batter-
ies. See
Battery Specifications on page
20.
•
Change the radio placement. Obstruc-
tions and operating indoors, or in vehi-
cles, may interfere. .
•
Verify that the radio is not in Scan mode.
See
Scanning Radio Channels on page
18.
Radios are too close. Ensure the transmit-
ting and receiving radios are at least 5 feet
(1.5 m) apart.
Radios are too far apart or obstacles are
interfering with transmission.
Recharge or replace Li-Ion battery.
NOTE: Extreme operating temper-
atures affect battery life.
See
Battery Specifications on page
Perform one of the following actions:
•
Verify that the radio and battery is prop-
erly inserted.
•
Check the battery and charger contacts
to ensure that they are clean and charg-
ing pin is inserted correctly.
See
Charging a Stand-Alone Battery with
the Drop-in Tray Charger on page 23
Charger LED Indications on page
VOX feature might be set to off. Use the
CPS to ensure the VOX Sensitivity level is
not set to 0.
Accessory not working or not compatible.
20.
and
25.