Motorola MCS 2000 Petunjuk Retrofit - Halaman 10
Jelajahi secara online atau unduh pdf Petunjuk Retrofit untuk Radio Motorola MCS 2000. Motorola MCS 2000 11 halaman.
Juga untuk Motorola MCS 2000: Panduan Instalasi (14 halaman), Panduan Pengguna (20 halaman)
Halaman Cetak
Mounting and
Connecting Control
Head
Mounting and
Connecting External
Loudspeaker
10
Existing Connector
Snip Wire Leads
Close to Connector,
Discard Connector
Figure 10 Removing Existing Connector from Remote Mount
2. Refer to Figure 8 and open the hinged door of the remaining
external loudspeaker connector included in the retrofit kit.
NOTE:
Do not strip insulation from pigtail
wires when performing next step.
3. Refer to Figure 9 and using a small screwdriver, press each of the
two unstripped pigtail wires from the remote mount control head
cable into one of the channels in the external loudspeaker
connector. Then close hinged door of connector firmly and
securely.
1. In Installation Manual 68P02058U20, refer to section titled
"Control Head Remote Mount Installation".
2. Mount control head trunnion (part of retrofit kit) in selected
location in vehicle using the two screws included with the
trunnion.
3. Secure control head into control head trunnion using the two
wingscrews included with the trunnion.
4. Route the remote mount control head cable from the radio body
to the control head.
5. Connect remote mount control head cable to control head and to
radio body.
1. In Installation Manual 68P02058U20, refer to section titled
"Remote Mount Installation" and mount external loudspeaker in
convenient location in vehicle.
2. Plug the new connector on external loudspeaker wire into new
external loudspeaker connector on remote mount control head
cable.
MAEPF-25544-O
Control Head Cable