Motorola MCS 2000 Petunjuk Retrofit - Halaman 8

Jelajahi secara online atau unduh pdf Petunjuk Retrofit untuk Radio Motorola MCS 2000. Motorola MCS 2000 11 halaman.
Juga untuk Motorola MCS 2000: Panduan Instalasi (14 halaman), Panduan Pengguna (20 halaman)

Halaman Cetak

Housing

Figure 6 Removing External Loudspeaker

Wires from Connector Pin Housing

Modifying External

Loudspeaker Wire

Remove

External Speaker

Wires from Locations

1 and 3

MAEPF-25542-O

8. If radio body is not being relocated, skip to step 10. Otherwise,

continue with step 9.

9. Extend all accessory wires so that accessory plug will reach new

location of radio body (see step 4).

10.Snap wings of accessory plug pin housing closed. Make sure that

pins on jumper wire and any other pins are seated correctly in pin

housing.

11.Insert pin housing back into shell in opposite way it was removed.

Be certain that 13-location side of pin housing is facing ﬂat side of

shell. Also be sure that pin housing snaps securely into shell and is

not cocked in shell.

12.Install top cover back onto accessory connector by snapping it

over the tabs and pressing down.

13.Reroute accessory wires and accessory plug to new location of

radio body.

1. Clip off the accessory plug pin from each of the two conductors

of the external loudspeaker wire.

NOTE:

The two external loudspeaker

connectors included with the retrofit

kit are identical.

2. Refer to Figure 8 and open the hinged door of one of the external

loudspeaker connectors included in the retrofit kit.

Insert Jumper

Between Locations

Housing

Figure 7 Inserting Jumper into Pin Housing

1 and 2

MAEPF-25543-O