ABB SPACOM 300 Panduan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pengoperasian untuk Relai ABB SPACOM 300. ABB SPACOM 300 8 halaman. Relay retrofit program cutting tool

R E L AY R E T R O F I T P R O G R A M C U T T I N G T O O L O P E R AT I N G G U I D E S PA C O M 3 0 0

—

3. Operating the cutting tool on a horizontal edge

3.1

3.2

3.3

Ensure that the cutting head is set in the correct

position. The text HORIZONTAL Up and Down must

point in the direction you are cutting.

Make four punches, side by side.

Ensure that you use the correct guiding,

before each cutting cycle.

After each cutting cycle, ensure that thecutting head

is clear of offcut!