Pioneer DEH-770 Panduan Pemilik - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pemutar CD Pioneer DEH-770. Pioneer DEH-770 24 halaman. High-power compact disc player with fm/mw/lw tuner
Halaman Cetak
Connecting the Units
cD
ee a disc is inserted in the built-in CD player, the unit will switch to
disc play mode. Pushing the button once again turns the power off.
@) Track Number Search
Press to search for a selection (track number) on the current disc. Press
the (+) side to increase the track number on the display, and the (—)
side to reduce the track number. Holding down either side of this button
changes the track number at high speed.
@) Music Repeat/Random Play
Use this button to select music repeat or random play mode.
Pressing
this button repeatedly cycles the mode through RPT, RDM, and normal.
(4) Release
Press this button to cancel music repeat, random play and highlight scan.
G) Volume
Press the (+) side to increase volume and the (—) side to decrease volume.
(©) Attenuator
Press to reduce the volume to 1/10
of its current setting (volume display
flashes). Pressing again returns the volume to its original level.
e This function is available using the remote controller unit only.
16
Before making final connections,
make temporary connections then
operate the unit to check for any connecting cord problems.
Refer to the owner's manual for details on connecting the various cords
of the power amp and other units, then make connections correctly.
Be sure to connect the memory power supply lead (orange) to a terminal
that is always supplied with power regardless of the vehicle's ignition
switch position. If this connection is made incorrectly or is forgotten,
the unit will not work at all.
Don't pass the orange lead through a hole into the engine compartment
to connect to the battery. This will damage the lead insulation and
cause a very dangerous short.
Since a unique BPTL circuit is employed,
never wire so the speaker
leads are directly grounded or the left and right speaker © leads are
common.
Speakers connected to this unit must be high-power types possessing
minimum rating of 25W and impedance of 4 to 8 ohms. Connecting
speakers with output and/or impedance
values other than those
noted here can damage the speakers.