Ariston MB 91 AUS Petunjuk Instalasi dan Penggunaan Manual - Halaman 7
Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Penggunaan Manual untuk Oven Ariston MB 91 AUS. Ariston MB 91 AUS 13 halaman. Maxioven
Halaman Cetak
Important: The appliance should be disconnected from
the mains supply before starting cleaning operations.
To ensure a long life cycle for the appliance, it is essential
to carry out a thorough general clean frequently, while
observing the following instructions:
Inside the oven door:
Clean the surface with a cloth moistened with hot water
and non abrasive liquid detergent, then rinse and dry
thoroughly.
Inside the oven:
• The inside of your oven is coated with a special self-
cleaning microporous enamel glaze which, at a normal
cooking temperature of between 200 and 300°C,
oxidises and completely eliminates all grease spots
or other substances that inevitably attack the inner
walls of the oven. This way, cleaning is kept right down
to a minimum: as a matter of fact, you just need to rub
the surfaces of the oven with a wet cloth regularly,
after cooking, to remove the thin layer of ash that may
have been deposited during cooking, in order to
maintain the self-cleaning property of the oven intact.
• After cooking where liquid has overflowed or when the
dirt has not been eliminated completely (for example
when grilling food, and the temperatures reached are
not high enough for the full self-cleaning action of the
enamel to be performed), we recommend you leave
the oven on at maximum temperature so that all grease
residue and the like are eliminated.
• If, after long-term use, you find evident grease stains
deposited on the self-cleaning oven walls, probably
due to your failing to follow the above maintenance
advice, clean the surfaces thoroughly with hot water
and a soft cloth (do not use any detergents), then rinse
and dry thoroughly.
• Do not remove any dry caked-on grease using sharp
objects, as these could etch the self-cleaning coating.
• If the self-cleaning surfaces inside the oven are
damaged or worn, due to incorrect or poor maintenance
or after many years of use, you can request a kit of
self-cleaning panels to line the inside of the oven. To
order these, just contact an authorised Service Centre.
Before cleaning your oven, or performing
maintenance, disconnect it from the power supply.
To extend the life of your oven, it must be cleaned
frequently, keeping in mind that:
•
The self-cleaning panels and the enameled parts
should be washed with warm water - abrasive powders
and corrosive substances should be avoided;
•
The inside of the oven should be cleaned immediately
after use with warm water and soap; the soap should
be rinsed away and the interior dried thoroughly;
•
Stainless steel can be stained if it remains in contact
with agressive detergents (containing phosphorus)
or water with a high lime content. We recommend
that you rinse these parts thoroughly and dry them
well after cleaning. It is also a good idea to dry any
water spills;
•
Never line the bottom of the oven with aluminium foil
How to Keep Your Oven in Shape
because the buildup of heat will not only impede the
cooking process, but could also damage the enamel.
Replacing the Lamp in the Oven
•
Cutoff the supply of power to the oven by turning off
the omni-polar switch connecting it to the mains, or
by removing the plug if it is accessible;
•
Unscrew the glass cover attached to the lamp holder;
•
Unscrew the lamp and replace it with another high-
temperature lamp (300°C) with the following
characteristics:
- Voltage: 230/240 V
- Wattage: 15W
- Socket: E14
•
Remount the glass cover and
reconnect the appliance to
the power supply.
Protective kit
During operation, the oven glass door and adjacent parts
of the appliance become hot. Make sure, therefore, that
children do not touch the appliance.
For greater safety, an additional child-safety device is
available from our Head Office and our Authorised
Service Centres (see enclosed list). When ordering this,
please give the code: BAB - followed by the appliance
model. The model is stamped on the plate which is
visible on the front part of the oven upon opening the
door.
Disassembling/assembling the oven door
To make it easier to clean the inside of your oven, the
oven door can be removed, by proceeding as follows
(fig. 1-2):
• Open the door completely and lift the 2 levers "B" (fig.
1);
• Now, shutting the door slightly, you can lift it out by
pulling out the hooks "A" as shown in figure 2.
To reassemble the door:
•
With the door in a vertical position, insert the two
hooks "A" into the slots;
•
Ensure that seat "D" is hooked perfectly onto the
edge of the slot (move the oven door backwards
and forward slightly);
•
Keep the oven door open fully, unhook the 2 levers
"B" downwards and then shut the door again.
Fig 1
6
Fig 2