Yamaha Arius YDP-160 Panduan Pemilik - Halaman 37

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Alat Musik Yamaha Arius YDP-160. Yamaha Arius YDP-160 44 halaman. Yamaha digital piano user's manual
Juga untuk Yamaha Arius YDP-160: Format Data Midi (6 halaman), Panduan Pengoperasian Cepat (2 halaman), Panduan Pemilik (44 halaman), Manual (44 halaman), Panduan pengguna (Denmark) (44 halaman)

Halaman Cetak
Yamaha Arius YDP-160 Panduan Pemilik
6.

Connect the pedal cord.

6-1 Insert the pedal cord plug to the pedal con-
nector from the rear.
6-2 Attach the cord holders to the rear panel as
shown, then clip the cord into the holders.
6-3 Use a vinyl tie to take up any slack in the
pedal cord.
6-3
6-2
7.
Connect the power cord (for
YDP-160) or power adaptor (for
YDP-140) to the unit.
YDP-160
7-1 Set the voltage selector (for models that fea-
ture a voltage selector).
127
240
Voltage Selector
Before connecting the AC power cord, check the set-
ting of the voltage selector which is provided in some
areas. To set the selector for 110V, 127V, 220V or 240V
main voltages, use a "minus" screwdriver to rotate the
selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially
shipped. After the proper voltage has been selected,
connect the AC power cord to the AC IN and an AC
wall outlet. A plug adaptor may be also provided in
some areas to match the pin configuration of the AC
wall outlets in your area.
7-2 Connect the plug on the power cord to the
YDP-140
7-1 Connect the DC plug of the power adaptor
6-1
CAUTION
Do not bend the cord tightly when you hang the cord on
the cord hook. Otherwise, a short-circuit or fire may
result.
WARNING
An improper voltage setting can cause serious damage to
this instrument or result in improper operation.
8.
Set the adjuster.
Rotate the adjuster until it comes in firm contact with the
floor surface.
9.
Attach the headphone hanger.
(for YDP-160 only)
Use the included two screws 5 (4 × 10mm) to
attach the hanger as shown in the illustration
below.
Keyboard Stand Assembly
rear panel connector.
to the rear panel connector, and loop cord
slack onto the cord hook so that the plug
will not be disconnected accidentally.
YDP-160/140
Owner's Manual
37