Zanussi ZDTS102 Panduan Pengguna - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Zanussi ZDTS102. Zanussi ZDTS102 20 halaman.
Halaman Cetak
Select and start a washing programme
Set the washing programme with the door ajar.
The washing programme only starts after you
close the door. Until then it is possible to modify the
settings.
Do these steps to set and start a washing programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting mode.
3. Press the programme selection/cancel button
again and again to set the washing programme.
Refer to the chapter 'Washing programmes'.
– The programme indicator light comes on.
4. Close the door.
– The washing programme starts automatically.
When the washing programme operates, you
cannot change the programme. Cancel the wash-
ing programme.
Warning! Only interrupt or cancel a washing
programme if necessary.
Caution! Open the door carefully. Hot steam can
come free.
Cancelling a washing programme
1. Press and hold the programme selection/cancel
button for approximately 3 seconds.
– The programme indicator light goes off.
– The end indicator light starts to flash.
2. Release the programme selection/cancel button to
cancel the washing programme.
At this time you can do these steps:
Care and cleaning
Warning! Switch the appliance off before you
clean it.
Cleaning the filters
Important! Do not use the appliance without the filters.
Make sure that the installation of the filters is correct.
Incorrect installation will cause unsatisfactory washing
results and damage to the appliance.
1. Switch off the appliance.
2. Set a new washing programme.
Fill the detergent dispenser with detergent before you
set a new washing programme.
Interrupting a washing programme
Open the door.
• The programme stops.
Close the door.
• The programme continues from the point of inter-
ruption.
End of the washing programme
Switch off the appliance in these conditions:
• The appliance stops automatically.
• The audible signals for the end of the programme
operate.
1. Open the door.
– The end indicator light comes on.
– The programme indicator light stays on.
2. Press the on/off button.
3. For better drying results, keep the door ajar for
some minutes before you remove the dishes.
Let the dishes cool down before you remove them from
the appliance. Hot dishes are easily damaged.
Removing the load
• First remove items from the lower basket, then from
the upper basket.
• There can be water on the sides and door of the
appliance. Stainless steel becomes cool more quick-
ly than the dishes.
11