Zanussi ZDTS102 Panduan Pengguna - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Zanussi ZDTS102. Zanussi ZDTS102 20 halaman.
Halaman Cetak
Important! Obey the instructions in the enclosed
template to:
• Build-in the appliance.
• Install the furniture panel.
• cConnect to the water supply and drain.
Install the appliance under a counter (kitchen worktop
or sink).
If a repair is necessary, the appliance must be easily
accessible for the engineer.
Put the appliance adjacent to a water tap and a drain.
For the venting of the dishwasher only water fill, water
drain and power supply cable openings are necessary.
The dishwasher has adjustable feet to allow the ad-
justment of the height.
Water connection
Water inlet hose
Connected the appliance to a hot (max. 60°) or cold
water supply.
If the hot water comes from alternative sources of en-
ergy that are more environmentally friendly (e.g. solar
or photovoltaic panels and aeolian), use a hot water
supply to decrease energy consumption.
Connect the inlet hose to a water tap with an external
thread of 3/4".
Caution! Do not use connection hoses from an
old appliance.
The water pressure must be in the limits (refer to 'Tech-
nical data'). Make sure that the local water authority
gives you the average mains pressure in your area.
Make sure that there are no kinks in the water inlet hose
and that the water inlet hose is not squashed or entan-
gled.
Turn the inlet hose to the left or the right to suit the
installation with the locknut. Fit the locknut correctly to
prevent water leaks.
Caution! Do not connect the appliance to new
pipes or pipes that are not used for a long time.
Let the water run for some minutes, then connect the
inlet hose.
Water inlet hose with safety valve
The water inlet hose is a double-walled and has an
inner mains cable and a safety valve. The water inlet
hose is under pressure only while the water is running.
Make sure that the water inlet hose, the drain hose and
the supply cable are not kinked or squashed, when you
insert the machine.
Attaching the appliance to the adjacent units
Make sure that the counter below which you attach the
appliance is a safe structure (adjacent kitchen units,
cabinets, wall).
Adjusting the level of the appliance
Make sure that the appliance is level to close and seal
the door correctly. If the level of the appliance is correct,
the door does not catch on the sides of the cabinet. If
the door does not close correctly, loosen or tighten the
adjustable feet until the appliance is level.
If there is a leak in the water inlet hose, the safety valve
interrupts the running water.
Be careful when you connect the water inlet hose:
• Do not put the water inlet hose or the safety valve in
water.
• If the water inlet hose or the safety valve is damaged,
immediately disconnect the mains plug from the
mains socket.
• Only let the Service Force Centre replace the water
inlet hose with safety valve.
Warning! Danger-
ous voltage
15