Zanussi ZSF2430 Panduan Pengguna - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring Zanussi ZSF2430. Zanussi ZSF2430 32 halaman.
Juga untuk Zanussi ZSF2430: Panduan Pengguna (16 halaman)

Halaman Cetak

Fault code and malfunction

• the drain pump operates continuously

• all indicators lights on the control panel

go off

The anti-flood device operates

The programme does not start

After the check, switch on the appliance. The programme

continues from the point of interruption. If the malfunction

shows again, contact your Service Force Centre.

For other fault codes, not described in the chart, contact

your Service Force Centre.

These data are necessary to help you quickly and correct-

ly:

• Model (Mod.)

The dishes are not clean

Limescales particles on the dishes • The salt container is empty.

The dishes are wet and dull

There are streaks, milky spots or a

bluish coating on glasses and

dishes

Dry water drop signs on glasses

and dishes

• Close the water tap and contact your local Service Force Centre.

• The appliance door is not closed.

Close the door.

• Mains plug is not connected in.

Put in the mains.

• The fuse has blown out in the household fuse box.

Replace the fuse.

• Delay start is set.

Cancel the delay start to start the programme immediately.

The cleaning results are not satisfactory

• The selected washing programme is not applicable for the type of load and

soil.

• The basket is loaded incorrectly so that water cannot reach all surfaces.

• Spray arm does not turn freely because of incorrect arrangement of the load.

• The filters are dirty or not correctly installed.

• The quantity of detergent is too little or missing.

• The water softener is adjusted on a wrong level.

• The salt container cap is not closed correctly.

• No rinse aid has been used.

• The rinse aid dispenser is empty.

• Decrease the rinse aid dosage.

• Increase rinse aid dosage.

• The detergent can be the cause.

Possible cause and solution

• Product number (PNC)

• Serial number (S.N.)

For these data, refer to the rating plate.

Write the necessary data here:

Model description : ..........

Product number : ..........

Serial number : ..........