Zanussi ZCG560G Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kompor Zanussi ZCG560G. Zanussi ZCG560G 20 halaman. Zanussi zcg560g cooker user manual
Juga untuk Zanussi ZCG560G: Panduan Pengguna (20 halaman)

Halaman Cetak

Important! When installation is complete, make sure that

the seal of each pipe fitting is correct. Use a soapy

solution, not a flame!

The gas supply ramp is on the rear side of the control

panel.

Warning! Before gas connection disconnect the

mains plug from the mains socket or switch off the

fuse in the fuse box. Close the primary valve of the gas

supply.

Gas connection point (only one point is applicable

for appliance)

Gasket

Adjustable connection

LPG pipe holder

The appliance is set to default gas, to change the

setting choose pipe holder No 4. Always use the

gasket sealing.

Adjustment to different types of gas

Warning! Let only an authorized person do the

adjustment to different types of gas.

This appliance is for operation with natural gas.

With the correct injectors, you can also operate it

with liquid gas.

Warning! Before replacing the injectors, make sure

that the gas knobs are in the off position. Let the

appliance cool off fully. There is a risk of injury.

Injectors replacement

Replace the nozzles when changing the gas type.

Remove the pan supports.

Remove the caps and crowns of the burner.

With a socket spanner 7 remove the injectors and re-

place them with the ones which are necessary for the

type of gas you use.

To assemble the parts, do the same steps in reverse.

Replace the rating label (it is near the gas supply

pipe) with the one for the new type of gas supply.

You can find this label in the package supplied with

the appliance.

If the supply gas pressure is changeable or different from

the necessary pressure, you must fit an applicable pres-

sure adjuster on the gas supply pipe.

Adjustment of minimum level

To adjust the minimum level of the burners:

Light the burner.

Turn the knob on the minimum position.

Remove the control knob.

With a thin screwdriver, adjust the by-pass screw

position. If you change from natural gas 20 mbar to

liquid gas, fully tighten the adjustment screw in. If

you change from liquid gas to natural gas 20 mbar,

undo the by-pass screw approximately 1/4 of a turn.

Minimum adjustment screw

Make sure the flame does not go out when you

quickly turn the knob from the maximum position to

the minimum position.

Oven injector replacement