Alecto WS-4800 Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Stasiun Cuaca Alecto WS-4800. Alecto WS-4800 16 halaman. Weather station with wireless outdoor sensor
Juga untuk Alecto WS-4800: Panduan Pengguna (17 halaman)

Halaman Cetak

7. MAX-MIN ALARM

7.1 Introduction:

For the following measurements you can set an alarm for when a maximum or minimum threshold is

exceeded:

Indoor temperature

Indoor humidity

outdoor temperature min/max alarm

outdoor humidity

Rainfall

Wind speed

7.2 To set Hi-Lo limits:

1. repeatedly press the

AL' next to it (if applicable)

2. use / to set the limit

3. briefly press the

4. press the

end automatically

7.3 Hi-Lo Alarm function setup:

1. repeatedly press the

AL' next to it (if applicable)

2. briefly press the button to enable or disable the selected alarm

7.4 Operation:

As soon as the set limit is exceeded, an alert tone will sound for up to 2 minutes while the concerned

display flashes and the alert indicator underneath the display flashes every 7 seconds. Briefly press the

button to stop the alert ton. The flashing stops automatically as soon as the concerned measurement

returns to within the set limits (or when you adjust the limit or disable the alarm function for the

concerned measurement).

8. RELATIVE AIR PRESSURE

8.1 Introduction:

When you're living considerable higher than the mean sea level, you'll be experiencing a lower air

pressure. To ensure that the weather forecast is still accurate, you'll need to correct the air pressure

according to your where you live.

8.2 Relative air pressure setup:

1. refer to the internet or your local authorities for information about your local air pressure

2. press and hold the

3. use / to select 'relative'

4. briefly press

5. use / to correct the display by setting it to the value you've obtained from your local authorities or

the internet

6. briefly press

min/max alarm

max alarm (only the actual rainfall from 00:00am is considered)

max alarm

button until the desired display is flashing with the indication 'HI AL' or 'LO

button again to save the value

button again to select the next display or wait several seconds for the setup mode to

button until the desired display is flashing with the indication 'HI AL' or 'LO

button for 2 seconds until 'absolute' or 'relative' starts flashing

and the air pressure display starts flashing

to save the air pressure