Aleko AC1400 Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuka Gerbang Aleko AC1400. Aleko AC1400 16 halaman. Sliding gate operator

AC1400 SLIDING GATE OPERATOR

is complete, return DIP switch 1 to OFF position immediately. Thus the auto-close

function has been canceled.

Pedestrian mode: Pedestrian mode can be used to open gate about 0.3~1.5 meters for

people pass through.

*Set width of pedestrian mode: Please turn on the first and the second DIP switch (See

Fig.7 No.18) to ON position. Press button 4 to open the gate (see Verify open direction

section), Wait until the gate travels the distance according to your requirements (the

distance range is 0.3m~1.5m or wait for 3~10 sec.), it is regarded as 'the width of

pedestrian mode'. Then press the same button/button 4 to stop the gate, wait for some

seconds (1~ 44 sec.). Close the gate by pressing the same button/button 4. Press the

same button again to stop the gate or the gate will stop automatically at its closed

position if the magnetic limit switch is reached. After this setup is complete, return DIP

switch 1 to OFF position immediately. Thus the width of pedestrian mode has been set.

If you open the gate with button 4, the gate will stop at the expected position that you

have set.

*Set auto-close function of pedestrian mode: Please turn on the first and the second DIP

switch (See Fig.7 No.18) to ON position. Press button 4 to open the gate (see Verify

open direction section), wait some seconds (3~10 sec.). Then press the same

button/button 4 to stop the gate, wait some seconds according to your requirements

(1~44 sec.), this period of time is regarded as 'auto-close time of pedestrian mode'. Close

the gate by pressing the same button/button 4. Press the same button again to stop the

gate or the gate will stop automatically at its closed position if the magnetic limit switch is

reached. After this setup is complete, return DIP switch 1 to OFF position immediately.

Thus the auto-close function of pedestrian mode has been set.

Note: the new width of pedestrian mode has been re-programmed in the device and

replaced the original width you have set in Set width of pedestrian mode section.

If you open the gate with button 4, the gate will stop at the new expected position that

you have set, after some seconds as what you have set, the gate will close automatically.

Cancel width / auto-close function of pedestrian mode

*Cancel both width and auto-close function of pedestrian mode: Please turn on the first

and the second DIP switch (See Fig.7 No.18) to ON position. Press button 4 to open the

gate (see Verify open direction section). Wait for more than 15 sec.. Then press the

same button/button 4 to stop the gate. Wait until the gate close automatically (45 sec.).

Press the same button to stop the gate or the gate will stop automatically at its closed

position if the magnetic limit switch is reached. After this setup is complete, return DIP

switch 1 to OFF position immediately. Thus the width and auto-close function of

pedestrian mode have been canceled.

*Cancel width of pedestrian mode, keep auto-close function of pedestrian mode: Please

turn on the first and the second DIP switch (See Fig.7 No.18) to ON position. Press

button 4 to open the gate (see Verify open direction section). Wait for more than 15

sec.. Then press the same button/button 4 to stop the gate. Wait some seconds

according to your requirements (1~44 sec.). Then press the same button/button 4 to

close the gate, press the same button again to stop the gate or the gate will stop

automatically at its closed position if the magnetic limit switch is reached. After this setup