Aleko AC1400 Panduan Pengguna - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuka Gerbang Aleko AC1400. Aleko AC1400 16 halaman. Sliding gate operator
Halaman Cetak
AC1400 SLIDING GATE OPERATOR
1. Important safety precautions
Carefully read and follow all safety precaution and warnings before attempting to install and
use sliding gate operator, incorrect installation can lead to severe injury.
Installing the AC1400 gate operator requires installation of standard 110V electrical
wiring. This work should only be performed by a trained technician. Miswiring could
cause personal injury or DEATH.
To prevent the risk of electrocution, be sure to turn off all power to the AC1400 until
installation is complete.
The gate operator should be installed by a qualified technician; otherwise, serious
personal injury or property damage may occur.
Before installation, the clutch should be unlocked.
The auto-reverse function must be checked during installation to ensure that the gate
can auto-reverse in the event of obstruction.
This auto-reverse function should be regularly inspected and adjusted, if necessary.
When opening or closing the gate, do not attempt to walk or drive through the gate.
Do not touch the gate while it is in operation.
Children should not be allowed to play near or operate automatic gate.
The automatic gate operator must be grounded.
Install the gate operator on the inside of the property, DO NOT install it on the outside of
the property where the public has access to it.
Be careful when in close proximity to moving parts where hands or fingers could be
pinched.
Additional safety equipment such as photoelectric sensors, safety edges, roller guards
and warning signs must be installed to prevent injury.
Do not allow control devices to be placed so that a person can access them by reaching
through the gate.
In the event of power failure, an emergency release key allows you to operate the gate
manually.
The operator should be switched off before repairing it or opening its cover.
Please erase and reprogram the code after installing the operator.
2. Main features
• Infrared safety beam interface.
• User programmable and user erasable remote codes.
• RF hopping code technology prevents your remote code being accessible to others.
• Supports up to 100 remote controls.
• For your safety, the AC1400 will stop and reverse if is encounters an obstruction on closing
and stop when it encounters an obstruction on opening.
• Manual key release design for emergency purposes.
• Auto-close feature is available for this operator.
• Pedestrian mode.
• Single Phase Motor.
3. Main technical parameters
Power supply
Motor speed
Gate moving speed
Required electrical circuit
Output torque
Auto close time
Table 1
AC 110×(1±10%)V, 60Hz
1680 r/min
10m/min
10A
14N·m
0~44 sec.
2