Aleko AC1400 Panduan Pengguna - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuka Gerbang Aleko AC1400. Aleko AC1400 16 halaman. Sliding gate operator

AC1400 SLIDING GATE OPERATOR

Fig.1

Installation and Adjustment

The AC1400 Chain-driven Gate Operator operates by forcing a straight piece of chain through

its chain box. This length of chain is extended between two chain brackets located at opposite

ends of the gate. The entire configuration is shown in the diagram above.

Concrete Pad

The base unit of the gate operator requires a concrete pad in order to maintain proper stability.

The concrete pad should be approximately 24" (600mm) x 12" (300mm) x 18" (460mm) deep

in order to provide for adequate operation.

Once the gate is mounted adequately, electrical power is available, and the concrete pad is

poured, you are ready to proceed.

Anchors

You can use the anchors that are provided with the operator, 3 ¾ anchor bolts (4), anchors,

washers, and nuts. These anchors must be set into the concrete when it is poured, or you

can use wedge anchors (1/4" x 4").

Operator Base

Mount the gate operator base to the concrete pad. The distance between the gate and the

base should be no more than 2 ½ " (64mm). Verify that the operator is leveled properly.