Lenovo ThinkServer Panduan Pengguna - Halaman 6

only in the ESD protective workstations. If ESD workstation is unavailable, please wear anti-static wrist strap

while holding parts and connect the wrist strap to the ground wire (that is, any unpainted metal surface)

of the server chassis to provide ESD protection.

ESD and holding system boards: Be careful when holding the system board. They are extremely

sensitive to ESD. Only touch the edge when holding the system board. Lay the system board with

components side facing upwards after taking the system board out of the protection bag or the sever.

Use the conductive foam pad (if any) rather than the system board package. Do not slide the system

board on any surface.

Installing or removing jumper: Jumper is a small plastic conductor between two jumper pins.

Some jumpers have a small wing on the top for you to use fingertips or fine needle forceps to clip it. If

the jumper has no such wing, be careful when installing or removing it with needle forceps, and clip the

jumper's narrow face instead of the wide one. Clipping the wide face will damage the contacts inside the

jumper, which will lead to intermittent faults to some functions controlled by the jumper. Clip the jumper

carefully with pliers or other tools and do not squeeze when removing it. Otherwise, pins on the system

board may be bent or broken.

ThinkServer Remote Management Module User Guide