Nikon Forestry Pro Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Alat Ukur Nikon Forestry Pro. Nikon Forestry Pro 48 halaman.
Juga untuk Nikon Forestry Pro: Buku Petunjuk (19 halaman)

Halaman Cetak

1. Internal Display

TO START:

1. Press POWER button to turn on.

2. Confirm your mode with the internal display (default is "last used" setting).

3. Set your desired mode and start measuring.

MODE setting:

・ Target Priority modes

・ Measurement modes

One-point (Act/Hor/Hgt/Ang) measurement

(Measurement order: Ⅰ ⇒Ⅱ⇒Ⅲ⇒Ⅳ⇒Ⅱ , then repeat)

Hgt

Internal display ("Linear distance mode")

(Display will be different depending on the setting mode.)

Ⅰ

Ⅱ

Set your desired

Aim at the target.

mode.

・ Power turns off 30 seconds after the last operation.

External display reading instructions

45.2

Hgt

12.7̊

Ang

Measurement Procedure Guide

- Press and hold MODE button, then press and hold POWER button within 0.5 second.

Continue to press and hold both buttons (more than 2 seconds) until First Target

Priority mode and Distant Target Priority mode are switched.

* If the button is not pressed within 0.5 second, the display unit <m/yd./ft.> will be

switched.

: Distant Priority mode (factory setting)

: First Priority mode

Press and release MODE button.

Measurement mode changes in the order of 1 (Act) to 6 (Hor) as shown below.

Holding down MODE button longer switches the display unit.

1. Act: Linear distance

2. Hor (solid): Horizontal distance

3. Hgt (solid): Height from horizontal

4. Ang: Angle (degrees) from horizontal

5. Hgt (blinking): Vertical separation (height between two points)

6. Hor (blinking): Three-point measurement (height between two points)

Ang

Hor

Ⅲ

Press POWER

button to measure

Keeping the button

pressed allows continuous

measurement of up to 20

seconds.

206.0

Act

201.0

Hor

(Actual external display image)

Target point

Act

Results display example

Ⅳ

Linear distance mode

Angle mode

All data below is displayed simultaneously.

of each mode.

Horizontal distance

mode

Height mode

Act (Linear distance)

Hor (Horizontal distance)

Hgt (Height from horizontal)

Ang (Angle from horizontal)