Discount Displays STDRD-MONITOR STAND Petunjuk Penyiapan - Halaman 2

Jelajahi secara online atau unduh pdf Petunjuk Penyiapan untuk Rak dan Dudukan Discount Displays STDRD-MONITOR STAND. Discount Displays STDRD-MONITOR STAND 3 halaman.

Halaman Cetak

ATTACHING AND SECURING THE MONITOR

Step 1: VESA Mount. Before attaching your monitor (not included), be sure the

top 2 screw holes on the back are 15.75" (400mm) apart.

Step 2: Determine the height you would like your monitor to hang.

NOTE: The holes on the frame will be at the same height as the screw holes

on the monitor.

Step 3: Pull the fabric away from the frame at the location of the desired screw

hole and attach the Monitor Profile Bar (G) using the T-Bolt and Wing Nut (H).

Step 4: Attach the appropriate T-Bolts (I) into the top screw holes on the monitor

and the correspondingly-sized Leveling Bolts (J) into the lower screw holes.

NOTE: The extra sets of bolts are for other mount patterns and will not be

needed. Do not screw bolts in too far as it can crack the screen. Most

monitors allow for at least 1/4" depth.

Step 5: Attach the monitor by adjusting the hook on one side of the Monitor

Profile Bar (G) so the ball is outside the groove allowing the T-Bolts (I) to slide into

the groove. Once both bolts are secured in the groove, re-adjust the hooks so the

ball is in the groove. This prevents the monitor from sliding off.

Step 6: Slowly tighten or loosen the Leveling Bolt for Monitor (J) to adjust the

angle of the monitor.

STDRD-MONITOR STAND

400mm (15.75")

6" or less

MOUNTING HOLES

STEP 1: VESA MOUNT

STEP 2: MONITOR PLACEMENT

STEP 4: BOLT ATTACHMENTS FOR MONITOR

BACK OF MONITOR