ARO GV08A-06S-7 Panduan Operator - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Operator untuk Alat Listrik ARO GV08A-06S-7. ARO GV08A-06S-7 12 halaman. Sanders/polishers

Halaman Cetak

SANDER/POLISHER SPECIFIC WARNINGS

FAILURE

TO OBSERVE

THE FOLLOWING

WARNINGS

COULD RESULT IN INJURY.

These Sanders and Polishers will operate at the

free speed specified on the nameplate if the air

supply line-furnishes 90 psig (6.2 bar/620 kPa) air

pressure at the tool. Operation at higher air

pressure will result in excessive speed.

Use only a sanding pad, buffing wheel or polishing

bonnet with these tools. Do not use any grinding

wheel, bur or metal removing accessory other than

a sanding pad with these tools. Never use an

accessory having a maximum operating speed less

than the free speed of the Sander or Polisher in

which it is being used.

When using a pad on a threaded arbor, make

certain the flange nut is tightened securely. Check

the tightness of the flange nut before operating a

Sander or Polisher to make certain it will not

loosen during operation.

Before installing a new Motor Housing Assembly,

always select the correct Assembly for the motor

package you are installing.

PLACING TOOL IN SERVICE

LUBRICATION

IRAX No. 10

IRAX No. 28

Always use an air line lubricator with these tools.

We recommend the following Filter-Lubricator-Regulator

Unit:

For USA - IRAX No. C11-03-G00

For International - IRAX No. C16-C3-A29

After each eight hours of operation, replenish the oil

supply. Adequate lubrication is imperarive for satisfactory

tool life.

After each 50 000 cycles or each month, whichever

occurs first, inject approximately 6 cc of IRAX No. 28

Grease into the Grease Fitting (4 1) .

INSTALLATION

Air Supply and Connections

Always use clean dry air at 90 psig. maximum air

pressure. Dust, corrosive fumes and/or excessive moisture

can ruin the motor of an air tool. An air line filter can

greatly increase the life of an air tool. The filter removes

dust and moisture.

Be sure all hoses and fittings are the correct size and are

tightly secured. See Dwg. TPD905-1 for a typical piping

AIR TOOL INLET SIZE

(Dwg. TPD905-1)

GV08A Sanders and Polishers are designed for standard duty sanding and polishing operations in automobile

repair shops and in sheet metal fabrication applications.