Aerial AP 50 Buku Petunjuk - Halaman 9
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengering Aerial AP 50. Aerial AP 50 17 halaman. Swimming pool dehumidifier
Juga untuk Aerial AP 50: Instruksi Manual Dan Garansi (14 halaman)
Halaman Cetak
6. Installation and transport
The AP-series is planned for the stationary effort. The units are for wall mounted
using. During the setting up and transportation of the dehumidifier, the following
items are to be considered:
Ø That dehumidifier can be transported upright or laid flat! The upright
transportation is to be preferred if possible. Secure against tilting!
Ø That dehumidifier must be installed so that the air can circulate without
obstruction through him. The air apertures – also the dorsal - must not be
covered. The open space before the main inlet and outlet apertures (front and
top) must at least conduct 1 meter. For an optimal air circulation it should be
clearly more than 1 mtr.
Ø The appliance must be used exclusively for air drying.
Ø The machine is to be fastened in each case to a wall. The mounting accessories
provided are to be used. The machine must be aligned with a spirit level on all
axles accurately.
ATTENTION:
The dryer is not suitable as seat furniture! Damages by inappropriate treatment
and use lead to expiring the guarantee!
6.1 Place of Installation
ATTENTION:
Before putting the air dryer into operation, the technical data of the appliance
should be compared to the conditions prevailing in the room of installation!
The suitable location for the AP-dryer should have / should be with:
Ø Electrical connection 230 V / 50 Hz.
Ø Above and in front of the dryer at least 1 meter free space, better more!
Ø Disposal possibility for the resulting condensate, if necessary with trap/siphon.
Select the location in such a way that the air of the dryer can circulate as optimally
as possible in the room. The dryer should be fastened to a wall. In the case of use
directly on the ground, the machine has to be fixed, too.
6.2 Fixing at a wall
Ø Mark the necessary boreholes for the mounting bar (lies with) at the wall.
Ø Align the bar thereby with a spirit level.
Ø Fasten the mounting bar reliably with the pegs and screws provided to the wall.
Ø The dryer is hung up later at this bar
page 9 of 17